Operation Manual

MG582-8M 3 Quick Introductions
3 Quick Start Guide
3.1 Power Supply
To supply power for the camera, four or eight size AA batteries are
needed.
Open the bottom cover. Confirm that the power switch is in the OFF
position and pull out the battery pack by pulling the silver handle. Load
the fully charged batteries into the pack according the polarities signs
shown below. Push the battery pack back into to the battery chamber.
The following batteries with 1.5V output can be used:
1. High-density and high-performance alkaline batteries
(Recommended)
2. Rechargeable alkaline batteries
3. Rechargeable NiMH batteries
There are four battery slots. Slot 1 and 2 form one group and is
marked “1”while slot 3 and 4 form the other group and is marked “2”.
Only one “group” of batteries is needed to supply power to the camera,
but both can be used and is recommended.
When in a low-battery state, the camera will be automatically shut
down after two indication sounds. Please change the batteries at this
time. If you have set the MMS function, it will send you a MMS/SMS or
Email to indicate the low battery situation.
Page 7