Operation Manual

MG882K-8M 2 Cautions
Page 6
2 Cautions
★ The working voltage of the camera is 6V. The camera is supplied by
four or eight AA batteries.
★ Please install batteries according to shown polarity.
★ Please unlock the write-protect before inserting the SD card.
★ Please insert the SD card when the power switch is in the OFF
position before testing the camera. The camera has no internal
memory for saving images or videos. If no SD card is inserted, the
camera will shut down automatically after a continuous indication
sound.
★ Please do not insert or take out the SD card when the power switch is
in the ON position.
★ It is recommended to format the SD card by the camera when used
for the first time.
★ The camera will be in USB mode when connected to a USB port of a
computer. In this case, the SD card functions as a removable disk.
★ In the TEST mode, the camera will shut down automatically after 3
minutes if no operation is done. Please turn on the power again if
you want to continue to work with the remote.
★ Please ensure there is sufficient power when having a firmware
upgrade, otherwise the upgrade process could be interrupted. If any
fault occurs after an improper upgrading process, the camera may
stop functioning properly.