Operation Manual

MG882K-8M 3 Quick Start Guide
Page 8
3.2 Insert the SD card and the SIM card
Open the bottom cover. Insert an SD card into the card slot with
unmarked side upwards. Please note that the SD card is on the “write”
(not locked) position otherwise the camera will not function correctly.
When using MMS/SMS/E-mail functions, be sure to insert a SIM card
into the SIM card slot with angle in the upper left.
3.3 Power On and Enter into the ON Mode
Before switching on, please pay attention to the following:
1. Avoid temperature and motion disturbances in front of the
camera such as a big leaf, curtain, air-conditioner, air outlet of the
chimney, and other heat sources to prevent from false triggering.
2. The height from the ground for placing the camera should vary
with the object size appropriately. In general, three to six feet is
preferred.
Slide the power switch to the ON position to power on the camera
and enter into the ON mode. Before entering into the ON mode, you
can adjust the camera towards the target monitoring area by laser
pointer.
After switching on the camera, the motion indication LED (red) light
will blink for about 10 seconds. The 10 seconds is a buffering time
before automatically capturing photos or videos, e.g. for closing and
locking the bottom cover, fixing the camera on a tree, and walking
away.