Operation Manual

4.4 Load or Remove a Wireless Sensor

Any 433 MHz wireless sensor, such as infrared body sensor, wireless

door magnet, wireless smoke detector, etc, can be set as an alarm sen-

sor of the camera.

Method to load or remove a wireless sensor:

1. Power on the wireless sensor.

2. Enter the Setup status, press Menu and enter into the Study

Code submenu. Choose a zone, for example Zone1, press OK button,

then trigger the wireless sensor to check if the sensor is loaded suc-

cessfully. When it's successful, there will be a “√” after the zone num-

ber.

For exampleto load a infrared body

sensor :

1. Choose a zone to start study

code.

2. Power on or trigger the wireless

sensor to study code