Operation Manual

NOTE
NOTENOTE
NOTE:
::
: Recomm
RecommRecomm
Recommendations for p
endations for pendations for p
endations for p
reparation work
reparation workreparation work
reparation work
• When installing, ask another
person
•
Wear protective gloves to prevent injuries from any sharp edges.
1
4
•
Determine the position of the extractor hood centrally above the hob in conformance with the
safety distances.
•
Mark the necessary holes for the wall mounting by using the supplied drill template and
spirit level.
• Drill Ø 8 mm mounting holes into
fasten the brackets with the
screws
•
Attach the suspension rail (1) for the hood body as well as the mounting rail with bracket (2) to the top
edge
parallel to the rail (1) (Fig. A). Determine the extension length of the duct cover
• Before suspending
insert the non
them.
For extraction mode:
For extraction mode:For extraction mode:
For extraction mode:
• Hereupon a
flexible extraction hose
(Fig. B)
and connected to the outside by the extraction outlet.
• Hook the extractor hood into the
suspension
•
Remove the protective plastic from the telescopic duct.
• Fix the outer (lower) duct with
the mounting rail without the bracket (3). The rail is fastened to the holes
provided from the inside of the duct.
19
reparation work
reparation workreparation work
reparation work
person
to assist.
Wear protective gloves to prevent injuries from any sharp edges.
2
5 6
Determine the position of the extractor hood centrally above the hob in conformance with the
Mark the necessary holes for the wall mounting by using the supplied drill template and
the wall for the respective brackets (1+2+3).
Insert
screws
(6).
Attach the suspension rail (1) for the hood body as well as the mounting rail with bracket (2) to the top
parallel to the rail (1) (Fig. A). Determine the extension length of the duct cover
insert the non
-
return valves (4) onto the extractor duct from above by gently bending
flexible extraction hose
(not supplied)
with an inner diameter of Ø 150 mm must be attached
and connected to the outside by the extraction outlet.
suspension
rail (1) (Fig. C). Check that it is se
cure
Remove the protective plastic from the telescopic duct.
the mounting rail without the bracket (3). The rail is fastened to the holes
provided from the inside of the duct.
Screw in two plate screws (7
) from the back (Fig. D).
3
7
Determine the position of the extractor hood centrally above the hob in conformance with the
specified
Mark the necessary holes for the wall mounting by using the supplied drill template and
check them with a
Insert
the dowel pins (5) and
Attach the suspension rail (1) for the hood body as well as the mounting rail with bracket (2) to the top
parallel to the rail (1) (Fig. A). Determine the extension length of the duct cover
in advance!
return valves (4) onto the extractor duct from above by gently bending
with an inner diameter of Ø 150 mm must be attached
cure
and horizontally level.
the mounting rail without the bracket (3). The rail is fastened to the holes
) from the back (Fig. D).