ELECTRIC OVEN EH 561 Instruction Manual
Contents Introduction ……………………..………………….………………………………………………….….... Page 3 General Notes …...……………………………………….……………………………………………..…. Page 3 Special safety Information for this Unit ……………………………...…………………………….......... Page 3 Unpacking the Appliance …...………………………………..…………………………………………… Page 5 Appliance Equipment ……………………..….………………………………………………………….... Page 6 Installation …...…………………………………………………………………………………………..…. Page 6 Startup / Operation ……………………..………………………………………..…………………..........
• The appliance is only to be used as described in Introduction the user manual. Do not use the appliance for any Thank you for choosing our product. We hope you other purpose. Any other use is not intended and will enjoy using the appliance. can an result in damages or personal injuries. • Do not use it outdoors. Keep it away from sources Symbols in these Instructions for Use of heat, direct sunlight light and humidity.
WARNING: • Make sure that the appliance is turned off from the power supply (fuse) before changing the bulb in the oven. • The use of high-pressure pressure cleaners or steam cleaners is prohibited. InI gress of liquids can lead to electric shock. Put the appliance never unu der water. WARNING WARNING: NING: Hot surface! surface! Risk of Burning! • During operation the appliance and the touchable accessories will be hot.
• Remove any possible spilled from the appliance cover before opening. Close the cover not before the hob has cooled down. • Never pour liquids into a hot oven! Scalding by rising water vapor as well as possible damage to enamel. • Do not place any objects on the open appliance door. • Do not store any cleaning agents or flammable materials in the appliance or in the immediate vicinity.
Installation location • To prevent hazards, check the appliance for any transport damage. CAUTION: CAUTION: • In case of damage, do not put the appliance into • The appliance must be installed so that heat can operation. Contact your distributor. be dissipated. The ventilation openings must not NOTE: NOTE: be blocked. Production residue or dust may have collected on the • Keep a distance of approx. 20 2 mm to the appli- appliance.
Drill two mounting holes • Arrange the mains cable in such a way that it Ø 7 mm at the respective does not get in contact with any hot components positions in the wall, meas- of the appliance. Do not lead it over sharp edges ured in a height from the or corners. ground level of about Connection wiring diagram 750 mm. Insert the dowels Permissible connection methods and screw in the hooks. CAUTION: • Connect the chains with the hooks.
NOTE: NOTE: NOTE: NOTE: The occurring odor and possibly a slight smoke If the recipe recommends putting the food in the prepr development cannot be avoided. Therefore ene heated oven only,, this should not be done before the sure for a good ventilation of the room during control lamp turns off for the first time. heating. 5 Power control lamp The power control lamp indicates the operation of the Operation appliances..
Switching on and off NOTE: NOTE: • Follow the instructions for the duration of the ...the oven completion in your recipes and preparation ini • Set the oven function selector switch to the ap- structions on the product packaging. propriate position. • Turn the oven temperature selector switch in Baking clockwise direction to the desired temperature. • For good baking results, preheating is recomreco • To switch the oven off, both switches must be mended up to the desired temperature.
• If possible, always cover the he cookware on the Removing the oven door cooking zone with a lid. You may remove the oven door to facilitate cleaning • Switch off the cooking zones before ending the and nd to get better access to the oven interior. cooking time, to use the residual heat. • Open the appliance door completely. • Push the retaining brackets bracket (a) of the hinges on both sides upwards. Cleaning and Maintenance • Slightly close the door and lift it up to remove it.
• Take off the glass carefully forward. Technical Data • Replace the glass panel and the retaining strip Electrical connection………………...………………….. properly; after you’ve ve cleaned the glass and dried Mains voltage: ………………...220-240 ………………...220 V~ / 380-415 V~ it thoroughly. Mains frequency: ………………………………...50/60 Hz Power consumption: ……………………….……..7800 ……………………….……..7 W Reverse the bulb Fuse protection: …………………………………..3 x 16 A WARNING: Protection class / degree: ……..
Disposal Meaning of the “Dustbin” Symbol Protect our environment; do not dispose of electrical equipment in the domestic waste. Please return any electrical equipment that you will no longer use to the collection points provided for their disposal. This helps avoid id the potential effects of incorrect disposal on the environment and human health. This will contribute to the recycling and other forms of reutilization of electrical and electronic equipment.
www.bomann.de 16 Stand 02/16 C.
