Operation Manual

28
Tips
Tips Tips
Tips for E
for Efor E
for Energy sav
nergy savnergy sav
nergy saving
inging
ing
• Disconnect the plug if you do not use the appliance.
• Do not install the appliance near stoves, heaters or other heat sources. In case of higher ambient
temperatures, the compressor will run more frequently and longer.
• Ensure sufficient ventilation at the bottom and rear side. Never block ventilation openings.
• Allow warm dishes to cool down before putting them in the appliance.
• Do not adjust the temperature colder than necessary. The ideal temperature in the fridge is 7°C.
• Make sure that the temperature in the freezer does not rise above -18°C.
• The appliance should be defrosted regularly.
• Do not open the door longer than necessary.
• The door seal must be completely intact, so that the door closes properly.
Cleaning and Maintenance
Cleaning and MaintenanceCleaning and Maintenance
Cleaning and Maintenance
WARNING:
WARNING:WARNING:
WARNING:
• Always switch off the appliance and disconnect the plug or turn off / unscrew the fuse before clean-
ing and user maintenance.
• Do not use steam cleaners for cleaning the appliance; moisture could enter electrical components.
Risk of electric shock!
Risk of electric shock!Risk of electric shock!
Risk of electric shock! Hot steam could damage the plastic parts. The appliance must be dry before
restarting operation.
CAUTION
CAUTIONCAUTION
CAUTION:
::
:
• Do not use a wire brush or other sharp, abrasive items.
CAUTION
CAUTIONCAUTION
CAUTION:
::
:
• Do not use any acidic or abrasive detergents.
• Do not damage the refrigerant circuit.
C
CC
Clean the
lean the lean the
lean the appliance including
appliance including appliance including
appliance including interior regularly:
interior regularly:interior regularly:
interior regularly:
• Remove the appliance content and storage at a cool location.
• Use warm water and a mild detergent for cleaning the appliance interior as well as the exterior.
• Clean the water discharge opening carefully with a pipe cleaner or knitting needle.
• After everything was thoroughly dried, you can restart the operation.
Interior light
Interior lightInterior light
Interior light
Lamp specifications: 220
Lamp specifications: 220Lamp specifications: 220
Lamp specifications: 220-
--
-240 V
240 V240 V
240 V ~ , max. 1
, max. 1, max. 1
, max. 1.5
.5.5
.5 W
WW
W
• Press gently on the center area of the lamp cover and remove it laterally downward.
• Replace the defect illuminant.
• Reattach the lamp cover.
• Reconnect the appliance and switch on again.