Operation Manual

23
• The seal of the appliance door must be complete- ly intact, so that the door closes properly.
Cleaning
CleaningCleaning
Cleaning and Maintenance
and Maintenanceand Maintenance
and Maintenance
WARNING:
WARNING:WARNING:
WARNING:
• Always turn off the appliance and disconnect the plug or turn off / unscrew the fuse before cleaning and
user maintenance.
• Do not use steam cleaners for cleaning the appliance; moisture could enter electrical components. Risk of
Risk of Risk of
Risk of
electric shock!
electric shock!electric shock!
electric shock! Hot steam could damage the plastic parts.
• The appliance must be dry before restarting operation.
CAUTION:
CAUTION:CAUTION:
CAUTION:
• Do not use a wire brush or other sharp, abrasive items.
• Do not use any acidic or abrasive detergents.
• Do not damage the refrigerant circuit.
Cleaning the appliance including interior
Cleaning the appliance including interiorCleaning the appliance including interior
Cleaning the appliance including interior
• Clean the appliance interior, the exterior surfaces,
the accessories and the door seal regularly with
warm water and mild detergent.
• Remove for that the appliance content and stor-
age at a cool location.
• Clean the thaw water discharge channel / opening
carefully e.g. with a pipe cleaner.
• After everything was thoroughly dried, you can
restart the operation.
Defrosting
DefrostingDefrosting
Defrosting
The fridge has an automatic defrosting system. Dur-
ing defrosting water drops drains off at the back of
the cooling chamber. The thaw water running
through a channel, is collected in a drip tray located
on the compressor, where it will evaporate. Make
sure the water discharge opening does not get
clogged. A light formation of ice on the interior back
during operation is normal.
To achieve better cooling and to save energy, defrost
the freezer regularly as follows:
• To start the defrosting process turn the tempera-
ture control to the off state and disconnect the
plug or turn off the fuse.
• Remove the food items and keep covered at a
cool location.
• When the ice has melted, wipe the condensate
away and dry the appliance interior.
• Then you may restart the appliance by connecting
the plug and turning the temperature control.
CAUTION
CAUTIONCAUTION
CAUTION:
::
:
Never use metal objects (e.g. knifes) to remove ice
from the evaporator. Otherwise it can be damaged.
A defect evaporator can cause serious damage.
NOTE:
NOTE:NOTE:
NOTE:
In order to speed up the defrosting process, you may
put a bowl of warm water (about 50°C) into the
freezer chamber.
Reverse the bulb
Reverse the bulbReverse the bulb
Reverse the bulb
Lamp specifications: 220
Lamp specifications: 220Lamp specifications: 220
Lamp specifications: 220-
--
-240 V
240 V240 V
240 V ~
~~
~ , max. 15 W
, max. 15 W, max. 15 W
, max. 15 W
• Unscrew the screw of the lamp cover.
• Press on the lamp cover and remove it to the
back.
• Replace the defective bulb.
• Reattach the lamp cover and tighten the screw.