Operation Manual
6
03/2014
Energy-test program in accordance with EU 1061/2010; Annex II:
Cotton 60°C/40°C, Standard Cotton. With complete filling and partial filling these standard washing cycles are for
the data determination on the energy label. These programs are suitable for washing normal soiled laundry and
on the combined energy and water consumption at the most efficient.
1)
The energy efficiency class is specified according to EU 1061/2010, Annex VI point 1.
2)
The weighted annual energy consumption in kWh/year and water consumption in l/year was calculated on the
basis of 220 standard washing cycles according to the EU 1061/2010, Annex II.
MANUFACTURER DATA: Product is subject to changes and improvements.
I
NSTALLATION
Remove the transport bolts
Before using this washing machine, the transport bolts must be removed from the backside of the
machine. Loosen all bolts with spanner and then remove them and keep the transport bolts properly
for future use/transport. Plug the holes with the transit bolts caps supplied.
Installation – place requirements -
- The device must be installed in a clean place, where dirty does not build up.
- A concrete floor is the most suitable installation surface for a washing machine, being far less
prone to vibration during the spin cycle than wooden floorboards or a carpeted surface.
- The machine must be level and securely positioned.
- Do not expose the device to direct sunlight.
- Do not place near heaters, next to a stove or any other heat sources.
- Avoid installation at locations with high humidity (e.g. outdoors), as metal parts would be suscepti-
ble to corrosion under such circumstances.
- Do not install in rooms where the temperature could drop below freezing. Do not expose the device
any weather.
- Do not place the device near volatile or combustible materials (e.g. gas, fuel, alcohol, paint, etc.).
- Only place on a steady and safe surface in order to reduce vibration and noise to a minimum.
- If the ground is evidently uneven (the maximum allowed tilt angle is 2°), it must be balanced; oth-
erwise the unit is wrong, vibrates or moves.
- If the floor is uneven, adjust the adjustable feet.
- Good ventilation around the unit is required so the heat can be derived correctly. The distance be-
tween the machine and wall must be more than 10 cm.
- The mains plug must be freely accessible.
Feet Adjustment (level adjustment)
Take care to a firm and horizontal position of the washing
machine. If the machine moves, adjusts the feet.
Loosen the locknuts with a spanner.
Adjust the feet:
The machine must stand perfectly level on all four feet to
ensure safe and proper operation.
Incorrect installation may increase electricity and water
consumption and may cause the machine to move about.
WARNING: Should the bolts
aren’t removed; there could be
serious damages during operation.
Transport bolts
NOTE: Keep the transit bolts
for future transportation. Whenever
the machine is transported, the
transit bolts must be refitted.