Operation Manual
7
03/2014
To do these when the machine is not level:
- Using the spanner, turn it locknut in a clockwise direction. Then turn locknuts together with adjust
feet to unscrew.
- Use a spirit level to check the machine is standing level.
-
Hold adjusts feet securely with a pipe wrench. Turn locknut again using the spanner until it sits
firmly up against the housing.
NOTE:
- The locknuts must be tightened after adjustment. Any looseness can cause vibration and noise.
- The feet must never be removed. Do not restrict the floor clearance through deep pile carpets,
strips of wood or similar. This might cause heat build-up which would interfere with the operation of
the appliance.
Water Connection
Install the Water Drain Hose
There are two ways to place the end of drain hose:
- 1. Hang into a sink or trough.
- 2. Connect it to the branch drain pipe of the trough.
1. If the outlet spigot has not been used before, remove any blanking plug that may be in place.
Push the drain hose onto the spigot and secure with a clip if required, ensure a loop is formed in
the drain hose to prevent waste from the sink entering the washing machine.
If you need a drain hose extension, make sure to use a similar drain hose, but it must be no longer
than 4 meters; otherwise the washing effect could be reduced.
2. It can drain the water up and down, the drain hose shall be installed at a height of min. 60 cm and
max. 90 cm about the ground and its end shall not be immersed in water.
Please use the supplied hose holder for flexible hoses to get a proper angle and secure it well to
avoid a change in position.
WARNING: Do not pinch the drain hose and do not place heavy objects on it: an uncontrolled
water flow can cause the machine to stop working.
Install the Water Inlet Hose (Cold Water)
Use the new included inlet hose to connect the machine at the water supply (cold water). Old hose-
sets should not be reused. Installation should comply with local water authority and building regulation
requirements.
- Connect the water supply hose to the tap with a 3/4"thread and tighten it firmly to the right.
- Connect the other end of the inlet hose to the inlet valve on the back of the device and tighten it
firmly to the right too.
Min. inlet water pressure 0.02 MPa
Max. inlet water pressure 0.8 MPa