Operator`s manual

.. CAUTION: Plastic alloy compo-
... nents such as fuel tank, wind-
shield,
etc., can be cleaned using mild
detergents or isopropylalcohol. Do not
use strong soaps, degreasing solvents,
abrasive cleaners, paint thinners, etc.
Chaincase
Drain the chaincase and refill to proper
level. To drain the chaincase remove
the access plug (lower plug) and tilt
vehicle hard left.
Drive Pulley
The drive pulley should be cleaned and
inspected. It also requires lubrication.
A WARNING: The lubrication of
T the drive pulley should be per-
formed only by an authorized
dealer.
Driven Pulley
The driven pulley should be cleaned
and lubricated on its inner faces to pre-
vent rust formation.
Fuel Tank and Carburetor
Remove the cap then using a syphon,
remove gasoline from tank.
A WARNING: Gasoline is flamma-
T ble and explosive under certain
conditions. Always manipulate in a
well ventilated area. Do not smoke or
allow open flames or sparks in the
vi-
cinity.
The carburetor must be dried out com-
pletely to prevent
gum formation dur-
ing the storage period.
Assure that the carburetor inlet fuel
line is disconnected. Remove the plug
. of the float chamber. Drain carburetor
into a container.
~
_____ -_______ ~'--"-~n
Reinstall the plug and connect the fuel
line.
Check all fuel lines, replace if necessa-
ry.
Cylinder Lubrication
Engine internal parts must be lubrica-
ted to protect the cylinder
walls from
possible rust formation during the stor-
age period.
O
NOTE: This operation should be
repeated every 40 days during
storage.
Remove the spark plug. Operate the
rewind starter to bring the piston at
top
position. Pour the equivalent of one
spoonful of
oil into spark plug hole.
Slowly crank the engine several times
using the manual starter.
Install the spark plug.
WI' CAUTION: To prevent ignition
'Y' system damage, make sure that
the cut-out lever isin the OFF position.
29