User manual

ᴑ WiFi Access Point: this setting is like HotSpot, but it relays

the wired Ethernet network instead of creating its own DHCP

server. It uses the same configuration and IP address as the

Ethernet network.

If Ethernet is configured as Master, any WiFi clients connect-

ing to this Access Point will be assigned an IP address by the

Ethernet DHCP server.

If Ethernet is configured as Client, connected WiFi clients will

get an IP address by the same remote DHCP server con-

nected via Ethernet (e.g., another BomeBox configured as

Ethernet Master).

In WiFi Access Point + Ethernet Client mode, if a

DHCP server is not reachable via Ethernet, con-

nected WiFi clients will not get an IP address and there

won't be wireless connectivity!

If Ethernet is configured as fixed IP address, all WiFi clients

connecting wirelessly to this BomeBox should also be config-

ured as fixed IP address in the same subnet as the Ethernet

IP address. Otherwise, there will be no connectivity!

Advanced Configuration

The advanced configuration will allow you to tune every aspect

of the network configuration of your BomeBox. The advanced

configuration is accessed via the small link at the very bottom

of every page of the Web Config.

Please use the Advanced Configuration with care,

and only if you know what you are doing!