User manual

ᴑ For devices in manual mode, you'll also find a Remove but-
ton. This will remove this manual entry in the list of devices.
If the corresponding device was an edited auto-detected de-
vice, the device will reappear under its own name.
You also have the following global settings:
ᴑ Auto-Enable devices: if this option is checked, all auto-de-
tected A&H mixers are automatically enabled whenever they
are detected. This setting is useful if you know that you
want to use all A&H mixers that are connected to the Bome-
Box via Ethernet. Manual devices are not auto-enabled.
Auto-enabled devices cannot be disabled.
ᴑ Auto-Create MIDI routes: if checked (the default), every
connected/enabled device will be fully routed via MIDI. In
the MIDI router, you will find routes which connect all other
non-A&H MIDI ports to this mixer, so that you can access it
from any other MIDI port. These Auto Routes can be dis-
abled, but not deleted, in the MIDI Routes Web Config page.
You can still add other manual routes using the A&H device
MIDI ports.
This setting is recommended if you mainly use the BomeBox
to access your A&H device(s) via MIDI.
ᴑ Add manual device by IP: press this button to add a man-
ual device (see Manual A&H Devices on page 23). You are
prompted to enter the IP address or network name of the
device to add. The default port number is 51325. You can
specify a non-default port number by appending it with a
colon. For example, to add a manual device at IP address
1.3.5.7 with port number 51327, enter “1.3.5.7:51327”.
Auto-Detected A&H Devices
Most newer A&H mixer devices are automatically detected and
appear in the list of devices. By default, they appear under
22