User manual

Password Reset
If you have forgotten your password for the Web Config, you
can reset it in a similar manner to resetting the network (see
previous chapter). All other settings, network configuration,
WiFi password, and project files remain the same.
1. Prepare a USB thumb drive to reset the password: it must
be FAT formatted, and not exceed 16GB in size.
2. Copy an arbitrary text file to the root folder of the thumb
drive, and rename it to:
{serial}_reset_password.txt
Replace {serial} with the serial number of that BomeBox,
as printed on the sticker at the bottom.
For example, if it is 00012345, then the name of the file
will be 00012345_reset_password.txt.
3. Attach that prepared thumb drive to the USB host connec-
tor of the BomeBox and power it up.
4. During the power-up process, the password is reset. You
may need to repeat this procedure once.
5. Now you can log into the BomeBox by using the default
password: the serial number.
6. Don't forget to unplug the thumb drive when done.
Reset to Factory Defaults
To remove all user files and reset all settings to their factory
defaults, you can use the Reset to Factory Defaults function:
1. Log into the Web Config, go to the Settings page
2. Go to the Backup & Firmware tab
3. In the Reset To Factory Defaults section, press the Perform
Reset button and acknowledge the security question with
OK.
4. Wait until the BomeBox restarted and the power LED stops
blinking. That first start takes approx. 2 minutes.
29