pebbles Don’t throw away! Design by Boris Klimek bomma Installation Manual for Pendant Light Fixtures
Introduction • Please read this user’s manual carefully prior to installation and follow its instructions and recommendations. • The installation of the pendant light requires more than one person. • For safety reasons, as well as for warranty purposes, it is forbidden to use this product in breach of this manual and other purposes stipulated in this manual. • Prior to assembly, use an appropriate circuit breaker to turn off electricity.
1 Upon opening, first determine that there was no damage occurred during transport and that the light fixture is complete. Otherwise, please contact your seller immediately, as later claims may not be considered. 1 Assemble the lighting fixture according to the manual, recognizing that its installation wiring may only be carried out by a qualified electrician following general legal regulations. Warning: Never unpack more than one light fixture at once to avoid mixing up components.
3 Slip the base-plate 4 on the incoming power supply cable from the ceiling and attach using appropriate screws and wall-plugs, which are not included in the package. Select their size and type according to the material of your ceiling and the weight of the light fixture. 4 4 Shorten the cable 5 to the required length, thread it through the central tube 6 through the canopy 7 and insert the cable into the reutlinger 8 . The cable end must protrude from the side hole by at least 25 mm.
5 Install the wiring according to the diagram. Attention! Wrong connection can destroy both the transformer and the light source.
6 Raise the canopy 7 onto the base-plate 4 and turn it so that the three screws on the inside of the canopy are inserted into the apertures in the support feet 9 .
7 Install the locking screw 10 completely. Congratulations! You may now reconnect the power and turn the light on. When dismantling, first turn off the light and disconnect from the power supply. Then follow the above steps in reverse order. Use the original or similar packaging for possible later transport of the light fixture to prevent damage.
Maintenance • When unpacking, installing and cleaning your fixture, handle the individual components with outmost care, particularly the glass parts, which are very fragile. • Assembly and electric installation must be carried out by certified electricians. • Pendant lights are intended for interiors. • We recommend consulting the installation and the anchoring of pendant lights in ceiling materials with your project manager, technician or another competent party.
Cleaning Important notice • All cleaning and maintenance must be carried out when the power is off, ideally entirely disconnected. • When cleaning, use fine-fabric gloves. Particularly avoid handling metalcoated crystal without gloves to avoid fingerprints and loss of gloss. • Use soft cloths to clean metal parts. Such parts may be cleaned with a dry cloth or a cloth dampened in warm water with a mild detergent. Avoid the use of solvents or technical benzene to clean metal parts.
Disposal Upon the expiration of the product’s shelf life, proceed in accordance to legal regulations for environmental protection and public health safety. Waste Materials Catalog Number Category Name 10 11 11* N Waste glass in small particles and glass powder containing heavy metals 10 11 12 O Waste glass other than those 17 04 01 O Copper, bronze, brass 17 04 05 O Iron and steel 20 01 01 O Paper and cardboard 15 01 05 O Composite packaging mentioned in 10 11 11 Contact BMRC GROUP s.
step beyond
