Installation Guide

4430 Gibsonia Rd. • Gibsonia, PA 15044 • USA • www.bontool.com
MOUNTING A DRILL CON’T
4. Drill with chuck and male Cam-Stud.
5. Slip the Ring-Clamp (#711)
over the drill and Drill Mount
Arms (#710).
6. Secure Ring-Clamp in suitable
place on drill. Avoid covering air
vents.
7. If needed, the Drill Mount Arms
(#710) can be extended back by
mounting the arms as shown with
two bolts.
CAM GUARD INSTALLING
1. Kitty-Corner Cam-Guard (#709)
into position between aluminum
supports.
2. Snap right and left sides of the
Cam-Guard on to plastic
tongue as shown.
OPERATION
1. Be sure forward/reverse
switch on the drill is in the
forward position. The
Quikpoint will only deliver mortar when the drill is in for-
ward rotation.
2. Load hopper with mixed mortar.
3. Hold the Quikpoint as in figure A. The oval nozzle can be
rotated for Vertical and Horizontal Joints.
4. For horizontal joints, the Quikpoint should be either
perpendicular to the wall or slightly angled away from the
direction of travel. Fill vertical joints from bottom to top.
5. The Quikpoint will deliver mortar straight down,
horizontally and up to a 55˚ angle above the horizontal.
Use angled nozzle #552-A for overhead applications.
CLEANING AND MAINTENANCE
1. Do not leave mortar in gun for more than one hour.
2. To clean gun, flush with water while gun is run-
ning. Do not use water hose to clean tool. Use only a
small con-
tainer to direct water into
the hopper without
spilling. Caution: Keep
water off of drill. Do not
immerse tool in water if
drill is attached.
3. Unplug drill. Remove
nozzle and clean mortar
from inside the nozzle holder and o-ring area of barrel.
4. Dried mortar in Allen set screw sockets can be cleaned
easily with a
1
/
8
” drill bit.
5. Occasionally apply a small amount of Vaseline or
Petroleum Jelly to the o-ring and nozzle Key groove at front
of barrel.
6. Where the Auger fits into
the Blade-Coupling
(#502) and the
Cam-Coupling (#703) put
Petroleum Jelly into the
holes to keep parts from
corroding.
7. Store tool in dry area.
MORTAR MIXES
The Quikpoint Mortar Gun works well with all standar U.B.C.
(universal building code) mortar mixes up to 2
1
/
2
fine sand by
volume to one part by volume of theh cements plus lime used.
The strength or P.S.I. of a mix is varied by the type of cement
used and the voluems of cement, lime and fine sand used. For
best results, the aggregate fine (sand) should not have
particales larger than
1
/
8.
”
3
2
4430 Gibsonia Rd. • Gibsonia, PA 15044 • USA • www.bontool.com
IS14188 08/09
PAGE 3 OF 4