Technical data

Bona MiniEdge
The main function of the machine is to serve as a complement to a belt or a drum sander for sanding
edges.
The machine is designed in accordance with latest information regarding ergonomics, safety and
efficiency. The machine has been thoroughly checked and approved before leaving the factory.
ASSEMBLY (Pict.
1)
1
Push the du
st tube into the dust bag. Tighten the dust bag with the Velcro
band on the tube. Put the dust bag with the dust tube back into the hole on
the motor bracket
.
N.B. When emptying the dust bag remove the dust tube together with the
dust bag completely, open the zipper and empty the content.
STARTING
Before starting the machine, instructions should be obtained from your dealer or Bona .
Never touch neither the sanding disc nor the sanding plate when the power cable is plugged in. For
security reasons, the extension cable must be unplugged from the motor cable when the machine is not
used.
Always unplug the machine and remove the cable from the wall outlet when maintenance job with the
machine is made.
2
SWITCHING
ON THE MOTOR
Starting instructions (Pict. 2)
Connect the machine cable to the extension cable. The machine must
always be started while tilting backwards with the sanding arm lifted from the
surface.
Stand behind the machine and hold both machine handles firmly while
pressing the start button on the side of the machine. The machine is ready
to run immediately after start.
The motor is provided with 0-tension release and overload protection. Always use original cable
(120V 3xAWG14 Article no: ASO901527) (230V 3 x 1,5mm2 Article no: ASO908215)
8