Instructions / Assembly

Instructions
6282254A
Instructions for replacement of Bonaire Durango Rooftop Filtercool pads
Before commencing any maintenance work on your unit, ensure it is
disconnected from the power supply.
1. Remove the Grill
a. Refer to the Owner’s manual for detail
2. Remove the old Filtercool pads
a. Remove the spike and clip (discs) that fasten the Filtercool pads to the grill and remove the
Filtercool pads.
b. After removing the Filtercool pads remove the spike and clip (discs) that fasten the Filtercool
pad to the grill.
c. NOTE: If the cooler has not previously had pads changed it may have integrated spikes
molded into the Rear panel. Integrated spikes may require removal.
3. Install the new Filtercool pad
a. Fit the Filtercool pad inside the grill.
b. Ensure the water distributor section is at the top of the Filter cool pad (see image below)
c. Secure the Filtercool pad using 4 spikes and clips. (see image below)
4. Refit the Grill
a. Refer to the Owner’s manual for detail
Water distributor
at top of pad
Grill
Clip (disc)
Grill
Integrated
Spike(x4)
Spikes (X4)