Use and Care Manual

Page | 11
Installation
BONAIRE WINDOW COOLER
Unit Window Installation
DO NOT connect the power to the cooler until the installation is complete.
Internal Fixing of the Unit
 IT IS MANDATORY THAT THE METAL FIXING BRACKETS SUPPLIED ARE FITTED TO
ENSURE A SECURE INSTALLATION. Utilize the 2 fixing brackets and 8 screws provided (4 x
Screw – 16mm Hi-Lo hex head and 4 x Screw – No. 8 x 1¼ pozi-drive) as shown in the diagram
to ensure the unit is adequately locked into position.
 Ensure that the bracket is aligned within the indicated mounting track area on the underside of
the fan housing – see diagram below. Drill 2x1/8” (3.2mm) holes and insert screws into unit as
per diagram and repeat for window frame with appropriate screws.
 Ensure that the cooler is now fixed rigidly to the house structure












 Close the window against the unit. Measure the gap of
the leftover window opening & then cut and fit an in-fill
panel to seal this gap (materials not provided). Seal any
gaps with silicone.
 Check that the unit is still level using spirit level on top
edge of Rear Filter Panel.
Installation