Manualshelf

Use and Care Manual

ManualsBrandsBonaire Durango ManualsEvaporative Coolers5,900 CFM 3-Speed Window Evaporative Cooler
11121314151617181920
Page | 13
Installation
BONAIRE WINDOW COOLER
Use the two ‘Wall Anchors’ provided to fix the cooler to the outside of the house if a ‘stucco-type’
wall is being used. (Note that if the unit is not hard up against the wall, these fixing screws will go
into the spacer block (2’ x 4’) already installed).
For solid walls, brick or masonry, use suitable masonry lag anchors.
Place the unit in position, mark screw positions, remove unit then drill pilot holes for timber walls
(1/8” or 3.2mm).
Replace unit in window, fit screws with Washers – 3/16 x 7/16 x 20g flat
Unit Wall Installation
DO NOT connect the power to the cooler until the installation is complete.
Contact a licensed contractor to have the cooler installed in an outside wall.