Use and Care Manual

Page | 4
Introduction
BONAIRE PORTABLE COOLER
Introducti on
General Information
Thank you for purchasing a quality Bonaire Evaporative Mobile Cooler. We care about your safety and
would ask you to spend a few minutes reading these simple instructions before operating this product.
Safety!
Read carefully all of these instructions prior to operating the unit.
· Read and Save these Instructions. Do not throw these Instructions away.
· Complete the unit assembly before attempting to operate.
· Interference with and operation of this cooler in any manner not prescribed by these instructions could
cause a safety issue and WILL void any warranty.
· Do not use cooler on uneven or unstable surfaces.
· Use only with a 110V 60Hz single phase grounded GFCI protected electrical receptacle.
· Do not operate cooler with Rear Filter Panel removed.
· Do not use immediately adjacent to heat sources such as stoves or radiators.
· Do not use the cooler immediately adjacent to sources of water, such as swimming pools, hot tubs,
bath tubs, sinks.
· Do not operate cooler with a damaged cord, plug or other component.
· Do not run the power cord under carpet or other floor covering.
· Do not use the power cord with an adaptor plug that converts the 3 pin plug into a 2 prong connector.
· Do not use the cooler with an improperly grounded outlet.
· Do not overfill. Use water only.
· Do not alter or modify this cooler.
· Do not allow children to operate or service this cooler.
· Lock all the wheels before operating cooler.
· Do not step on or roll over power cord with heavy or sharp objects.
· Remove the plug from the electrical receptacle by pulling on the plug and not the cord.
· Never wash the unit cabinet with a garden hose: water may harm the motor and electrical system.
· WARNING: To reduce the risk of fire or electric shock, do not use this product with any solid state
speed control device.
· Use only qualified electricians for replacement or servicing of switches, or electrical motors and
components in this cooler.
· Unplug the cooler and position the rotary control knob to the OFF position when servicing or cleaning.