Use and Care Manual

Page | 8
Installation
BONAIRE PORTABLE COOLER
Water Connection / Tank Filling
This unit is compatible with a standard garden hose connection.
Use standard ¾” connection to connect water to the unit.
The overflow is factory fitted. If unit is inside then bleed hose
should be kept inside the tank and regular draining of the tank
will be required. If unit is outside then bleed hose should place
through the overflow fitting SHOULD bleed water during normal
operation at a rate between 6 – 12 Litres per hour (1.5 – 3
gallons per hour). This is normal and is designed to preserve
the quality of the Cooler and Cooling efficiency of the Unit.
The float valve is factory set and should require no further
adjustment at time of installation.
As an alternative to hose connection, the tank can be manually
filled through the ice door of the front of the unit. The water level
should be set its maximum limit as shown on overflow.
Note: Water supply line to float valve must be flushed before connecting.
Overflow
Float
Valve
Maximum
Water Level
Hose Connection
1.Open the Ice door
2.Slide down the Ice door