Owner's manual

Multi-Appliance Comfort Control

Navi

atin

the Controls

FAULT CODE RECALL

• Press & release SET TIME/PROGRAM and ENTER

simultaneously for 10 seconds to display the last fault

code.

• Use the up arrow to display the last 4 fault codes.

SETTING DAY AND TIME

After installing batteries for the first time or replacing old batteries (RF hand held model), or after a power

cut (Low voltage hard wired model), the display will indicate OFF and the day and time when the

batteries/power were last removed.

ET TIME

Using SET TIME mode:

1. Press ON/OFF to switch the controller ON.

2. Press & hold the SET TIME/PROGRAM button for more

than 2 seconds until TIME flashes. A DAY will also flash

on the bottom row of the display.

3. Press ▲ to advance to next day or ▼ for previous days.

4. Press ENTER to select the day. The DAYS will stop

flashing and the HOURS segments will flash.

5. Press ▲ to advance to next hour or ▼ for previous hours.

6. Press ENTER to select hour. HOUR will stop flashing and

MINUTES will flash.

7. Press ▲ to advance to next minute or ▼ for previous

minutes.

8. Press ENTER to select minutes.

9. Press SET TIME/PROGRAM to exit the time setting mode

at any stage.

12/24

HOUR CLOCK

To change between the 12 hour and 24 hour clock modes

1. Press & hold the SET TIME/PROGRAM button for more

than 2 seconds until TIME flashes.

Comfort Control - PNE

Page 11