H2Optimiser Water Management System Suits Bonaire Integra Owner’s Information
INSTALLATION / MAINTENANCE INSTRUCTIONS H2Optimiser Introduction Your new Bonaire Integra has been fitted with an H2Optimiser water management system. This H2Optimiser is designed to give increased water savings through controlled management of the maintenance water. All units using conventional bleed and dumping systems require regular bleeding or dumping of the water during each day.
INSTALLATION / MAINTENANCE INSTRUCTIONS H2Optimiser Installation The Integra unit comes with most of the H2Optimiser components already installed. • The CARE-FREE Water Conditioner A/C 6 is installed in the water distribution circuit. • The water outlet solenoid and overflow fitting have been installed and the wiring loom is connected to the control board. • The water inlet valve loom has been connected to the control board.
INSTALLATION / MAINTENANCE INSTRUCTIONS H2Optimiser Maintenance Requirements 1. Start Up Maintenance:With a new product there is the opportunity for new product residuals to make their way into the water reservoir. After approximately 8 hours of operation, check the following:• Check and clean out any water blockage in the A/C6. • Check and clean out any water blockage in the water outlet solenoid filter. • The unit tank / reservoir may need to be cleaned out.