Manual

Multi-Appliance Navigator Control
Navigator Control
Page 35
Ducted Evaporative Air Conditioning
29. PROBLEM SOLVING
PROBLEM
PROBABLE CAUSE REMEDY
a Black – out a Wait
b Tripped Circuit Breaker b Reset
c Blown Fuse c Replace
Unit fails to start
d Electrical Fault d Place a service call
a Pump Seized a Place a service call
Pump fails to start
b Pump Burnt Out b Place a service call
a Float Valve Leaking a Check adjustment or replace
seal
Water leaking from
overflow
b Drain from Celdek Pads b Normal Operation
a Loose Delivery Tube a Place a service call
b Break in tubing b Place a service call
Water Droplets in
air stream
c Pump Delivers Excessive Water to
Pads
c Adjust dial flow valve
a Inadequate Exhaust a Provide more open area to
exhaust stale air
Excessive humidity
b Outside humidity high b Turn pump off.
a Dirty Filters a Place a service call
b Dry Filters b Place a service call
Inadequate Cooling
c Dialflo not set correctly c Adjust dial flow valve
a Unit located near odor source a Remove source
Unpleasant Odor
b New Celdek filter smell b Smell will disappear after a
period of operation.
Rapid formation of
white deposits on
pads
High Mineral Content Call Installer
THIS TROUBLE SHOOTING GUIDE IS A REFERENCE ONLY.
FOR SERVICE OR WARRANTY REQUIREMENTS PLEASE REFER
TO THE LAST PAGE OF THESE INSTRUCTIONS