Use and Care Manual

10
Appliance
emits a lot of
black smoke
when lit
Flame is obstructed at burner
ports
Make sure all the gas burner ports are
free of any lava rocks or debris to allow
the
g
as to flow freel
y
.
Regulator hose is pinched
Check the regulator hose for bends or
kinks
Sudden drop in
gas flow
No gas flow
Check if gas cylinder is empty. If yes,
replace.
Excess flow safety valve has
been activated
Turn the control knob to "OFF", close the
LP tank valve and disconnect the
regulator from the tank. Turn the control
knob to "HIGH". Wait 1 minute. Turn the
control knob to "OFF". Reconnect
regulator to LP tank. Open tank valve
Flame blow
out
High or gusting winds
Increase flame to "High"
No gas flow
Check if gas cylinder is empty. If yes,
replace.
Excess flow safety valve has
b
een activate
d
See "Sudden drop in gas flow" above
slowly.Light appliance as indicated in
the"To Light"section.
Irregular flame
pattern or flame
does not come
out of the entire
length of the
b
urne
r
Burner ports are clogged
See "Burner will not light using a match"
above.
IF YOU HAVE QUESTIONS OR CONCERNS
PLEASE CALL BOND TOLL FREE #1 866 771-BOND(2663)
EXPEDITE YOUR REQUEST FEEL FREE TO EMAIL US
[e-mail]
OR VISIT OUR WEBSITE UNDER CUSTOMER SERVICE SUPPORT
www.bondmfg.com
BOND MANUFACTURING CO.
1700 West 4th Street, Antioch,CA 94509