Instructions / Assembly

1
2
3 Open LP tank valve slowly.
4
5
6
7
8
1
2
3
4
5
6
7
8
Flame height can be changed by adjusting the burner control knob between the "LOW" and
"HIGH" positions.
Always check burner flames periodically to ensure proper operation. Flames should be mostly
yellow with some blue for best performance.
Before lighting, move the lava rocks with a small shovel to allow access to the burner.
WARNING: Lava rocks can become very hot. DO NOT touch unless they are completely cooled.
If ignition does occur within 5 seconds, turn the burner control knob to "OFF", wait 5 minutes for
gas to clear and repeat the lighting procedure. If burner still will not light, refer to the
Troubleshooting Section.
Locate the burner control knob and make sure it is in the "OFF" position.
USING A LONG MATCH OR LIGHTER
Locate the burner control knob and make sure it is in the "OFF" position.
Push in igniter button to create sparks at the electrode and hold.
●Check and make sure that all parts are present.
Connect propane (LP) cylinder. (See above pages).
Connect propane (LP) cylinder (see above pages).
●For future reference, save this instruction sheet.
TO LIGHT
TIPS:
Before Beginning ●Read and understand the instructions thoroughly.
Wearing heat resistant gloves, position a long lit match or lit long neck lighter close to the burner
ports. DO NOT lean over the burner while lighting.
Always check burner flames periodically to ensure proper operation. Flames should be mostly yellow with some blue for best
performance. (See diagram)
CAUTION
If the burner does not ignite with the burner control valve open, gas will continue to flow out of the burner and could
accidentally ignite causing injury or property damage.
If ignition does occur within 30 seconds, turn the burner control knob to "OFF", wait 5 minutes for gas to clear and repeat the
lighting procedure. If burner still will not light, refer to the Troubleshooting Section.
Push and turn burner control knob to the "LOW" position. The burner should lit within 5 seconds.
Once the appliance is lit, flame height can be changed by adjusting the burner control knob between the "High" and "Low"
Push and turn burner control knob to the "LOW" position. Continue to push the control knob for 15-30 seconds after ignition.
9