Use and Care Manual

5
3
. Put the gas tank on top of tank holder
(D).
Make sure the gas tank sits on the tank holder
D
completely.
Turn the wing screw on the outer part of tank
holder clockwise to secure the gas tank
tightly.
4 . This item requires a 20 lb. propane
tank (not included) in order to operate
correctly. To install the tank to the
firebowl, first turn the cylinder valve on
the tank clockwise to close the gas supply
on the gas cylinder. Then, screw
the
regulator coupling from inside the
firebowl onto the valve clockwise by
hand only. Make sure it is fastened.
OPERATING INSTRUCTIONS
Perform a leak test in a well-ventilated area outside and where no source of spark can occur. DO NOT
cover firebowl directly after flame is out. Wait 5 minutes for firebowl to cool prior to placing cover on
firebowl. Connect tank cylinder to regulator. Turn the on/off valve on the unit to the ‘OFF’ position to
pressurize the control system. Use a soapy water solution to check all the connection leaks before
attempting to light the
firebowl
.
If a leak is found or you smell gas, disconnect cylinder and turn valve off and do
not use the firebowl until repairs can be made.
Cover must be removed when burner is in operation.
Firebowl and propane gas cylinder minimum distance
must be over 60'' (as per the right side photo).