Use and Care Manual

7
TO LIGHT
• Check each part before using the product.
•
Be sure to remove any cover before lighting the firebowl.
•
Control knob must be in the OFF position. Connect propane cylinder and open cylinder valve.
•
A pulse igniter is built into the control knob so pushing and turning the control knob counterclockwise to the
HI. position will ignite the fuel.
•
If ignition does not immediately take place in seconds, push and turn the control knob clockwise to OFF,
wait 5 minutes, and then repeat the lighting procedure as above.
• To adjust the flame, turn the control knob either clockwise or counterclockwise depending on whether you
want to lower or raise the flame. Observe flame height when lit; flame should be a yellow/blue color
between 2 to 10 inches high.
•
Be sure to observe the firebowl flame; if the flame patterns appear abnormal, adjust the control knob
again.
• Please keep gas tank a minimum of 5 feet away from firebowl when lit.
Observe flame height when lit:
Flame should be a yellow/blue color between
2 to 10 inches high.
TO EXTINGUISH
•
Push and turn the control knob clockwise to the OFF position.
• Close cylinder valve and disconnect propane cylinder.
CAUTION: Disconnect propane cylinder when this firebowl is not use.
ROUTINE CARE
※ Keep your firebowl free and clear from combustible materials.
※ Visually inspect burner from obstructions and keep firebowl free and clear from debris.
※ After the burner and lava rocks are completely cooled down, use a soft brush to get rid of the mild stains, loose dirt
and soil. Wipe with a soft cloth.