Use and Care Manual

3
FOR PROPANE GAS UNITS
*The gas pressure regulator provided with the propane fire table must be
used.
*Do not attempt to disconnect the gas regulator or any gas fitting while your fire table is in
operation.
*A dented or rusty propane cylinder may be hazardous and should be checked by your gas supplier prior to
use.
*Do not use a propane cylinder with a damaged valve and any other worn out
parts.
*Transit and store the empty gas cylinders carefully and
properly.
*If you see, smell or hear the hiss of escaping gas from the propane
cylinder:
1. Turn off the gas supply and get away from the gas cylinder and the fire table at
once.
2. Do not attempt to correct the problem
yourself.
3. Get to your gas supplier and/or the fire department for
help.
Children and adults should be alerted to the hazards of high surface temperatures and should stay away to
avoid burns or clothing ignition.
• Young children should be carefully supervised when they are in the area of the
appliance.
• Clothing or other flammable materials should not be hung from the appliance, or placed on or near the appliance.
• Any guard or other protective device removed for servicing the appliance must be replaced prior to operating the appliance.
• Installation and repair should be done by a qualified service person. The appliance should be inspected before use and at least annually
by a qualified service person. More frequent cleaning may be required as necessary. It is imperative that the control compartment,
burners and circulating air passageways of the appliance be kept clean.
Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas
control which has been under water.
• Use only the specific size and capacity of the cylinder noted
.
• A statement that the LP-gas supply cylinder to be used must be constructed and marked in accordance with the specifications for LP-
gas cylinders of the U.S. Department of Transportation (DOT).
• This appliance shall be used only outdoors in a well-ventilated space and shall not be used in a
building, garage or any other enclosed
area as the instructions state.
•How to disconnect a gas bottle
Turn OFF control knob and LP cylinder valve. Turn coupling nut counterclockwise by hand only - do not use tools
to
disconnect. Loosen cylinder screw beneath bottom shelf, then lift LP cylinder up and out of shelf. Place dust cap on cylinder
valve outlet whenever the cylinder is not in use.
• Storage of an appliance indoors is permissible only if the cylinder is disconnected and removed from the appliance. Cylinders must be
stored outdoors in a well-ventilated area out of reach of children. Disconnected cylinders must have threaded valve plugs tightly
installed
and must not be stored in a building, garage or any other enclosed area.
WARNING: Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to
the
owner’s information manual provided with this appliance. For assistance or additional information, consult a qualified installer, service
agency or the gas supplier.
• The LP-gas supply cylinder must be disconnected when this appliance is not in use.
• Only cylinder marked “propane” shall be
used.
Caution:
Only use the pressure regulator and hose assembly supplied with this fire table. Replacement pressure regulator and hose
assemblies
must be specified or supplied by BOND MANUFACTURING CO.