Instructions / Assembly

Shut down

■

Turn Control Knob clockwise to Pilot.

(Normally, burner will make a slight popping

sound when extinguished.) Burner will

extinguish but Pilot will remain ON.

■

To extinguish Pilot, depress Control Knob

and continue to turn it clockwise to OFF.

(See Figure 20).

■

Turn off gas supply at the valve of gas

cylinder.

■

Disconnect the cylinder and remove when

the heater is not in use.

Figure 20

Storage

Note: Wait until heater is cool before covering.

When heater is not in use for a prolonged period of time, remove gas cylinder.

Verify that the gas cylinder valve is closed tightly.

Do not store the gas cylinder indoors, store gas cylinder in a well ventilated area.

Maintenance

To obtain the best performance from your heater make sure you perform the following

maintenance activities on a regular basis:

■

Keep exterior surfaces clean. Use warm soapy water for cleaning. Never use flammable

or corrosive cleaning agents. Be sure to keep the area around the burner and control

assembly dry at all times.

■

Keeping the ventilation openings of the cylinder enclosure free and clear from debris.

Visually checking burner flames with pictorial representations

shown on page 11.

■

Airflow must be unobstructed. Clear insect nests or webs away from your heater’s

exterior and interior using a straight piece of wire and wire brush or vacuum cleaner at

least once a year or immediately upon indication of any of the following systems:

a. Flashback

b. Smell the fuel gas

c. Predominate yellow flames

d. Excessive popping noises during operation

e. Uneven emitter glow

Carbon deposits may create a fire hazard. Clean dome and emitter with warm soapy Water if

necessary.

Caution:

Never use wood or plastic, it may break and block the parts.

Never spray any cleaning product on the emitter grid or burner area.