Instructions / Assembly

ASSEMBLY INSTRUCTIONS

* Please keep these owner's manual for future reference.

*If you have opened the carton and removed all packages, please disregard the STEP 1 and 2. See the STEP 3

directly.

** DO NOT COVER THE IGNITION SCREEN when

placing the lava rock into the fire bowl. Always keep

Ignition Screen visible.

** Connect the Pressure-Regulating Valve to the gas tank.

See Figure VI.

1) Turn the cylinder valve clockwise to close the gas

supply on the gas tank.

2) Screw Regulator Coupling clockwise by hand only.

Make sure it is fastened.

STEP 2. (1) Turn the firebowl heads up on a flat ground.

(2) Cut off the binding tape on the polyfoam and remove all

the polyfoam rounding the top of the firebowl.

(3) Cut off the tie fastened to the regulator at the metal stand

and set it free for installation to Propane Tank.

See Figure STEP 2.

STEP 1. (1) Open the carton and turn it upside down, make sure the

4 pieces of the carton being open up as below Figure STEP 1.

(2) Lift off the carton carefully and be wary of the accessories inside

falling away. Take away the box containing lava rock.

(3) Take all the packing materials away except for the polyfoam

rounding the top of the firebowl. See Figure STEP 1.

STEP 4.

(I) Check each part before using the product. Make sure the gas

supply system is turned "OFF" before assembling. See Figure I.

(II) Open the storing door on the firebowl for the gas tank. See

Figure I.

(III) Put the gas tank in the metal stand. Make sure the gas tank sits on

the metal stand completely. Turn the wing screw on the outer part of

metal stand clockwise to secure the gas tank tightly. See Figure V.

(IV) Locate the battery, remove the plastic cover first. Unscrew the

rubber cap of the Electric Ignitor, place a AAA battery into the battery

case. Make sure the positive pole ("+") towards the cap. Screw the

cap back to the battery case tightly.

See Figure II.

(V)

Place the lava rock averagely in the fire bowl on the top of the

firebowl. See Figure III.

Step 3.

Attach the 4pcs of panel using 8pcs M6 x 10 screw and 8pcs washer.

Attach the 4pcs of panel to the table top using 8pcs M6 nut and 8pcs

washer.

Step3