Instructions / Assembly

ManualsBrandsBond ManualsKitchenPortable Propane Gas Grill

80102

Owner’s Manual

Portable Gas Barbecue Grill

WARNING

Improper installation,

adjustment, alteration, service or

maintenance can cause injury or

property damage.

Read the installation,

operation and maintenance

instructions thoroughly before

installing or servicing this

equipment.

DANGER

Failure to follow these

instructions could result in fire

or explosion that could cause

property damage, personal

injury or death.

DANGER

DO NOT use gas grill for indoor

cooking or heating. TOXIC

fumes can accumulate a

cause asphyxiation. DO NOT

use in or on boats or

recreational vehicles.

PROP 65 WARNING

Chemicals known to the state of

California to cause cancer, birth

defects or other

reproductive

harm are created by the

combustion of propan

WARNING

FOR YOUR SAFETY:

For Outdoor Use Only

(outside any enclosure)

SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

IF YOU ARE ASSEMBLING THIS UNIT FOR SOMEONE

ELSE, GIVE THIS MANUAL TO HIM OR HER TO SAVE FOR

FUTURE REFERENCE.

FOR CUSTOMER SERVICE, EMAIL TO

customerservice@bondmfg.com

WARNING

FOR YOUR SAFETY:

For Outdoor Use Only

(outside any enclosure)

Printed in China

MODEL# 80102

IF YOU HAVE QUESTIONS OR CONCERNS

PLEASE CALL BOND TOLL FREE #

1-866-771-BOND(2663)

Summary of content (16 pages)

PAGE 1
MODEL# 80102 Portable Gas Barbecue Grill WARNING Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Read the installation, operation and maintenance instructions thoroughly before installing or servicing this equipment. DANGER Failure to follow these instructions could result in fire or explosion that could cause property damage, personal injury or death. DANGER DO NOT use gas grill for indoor cooking or heating.
PAGE 2
Grill Operation 1-2-3 Before Grilling Step 1 Step 2 Step 3 Keep your grill a safe distance away from your property.* Always perform a Leak Test on all connections. * Keep children away from the grill. During Grilling (To avoid tripping safety valves, please follow these instructions carefully.) Step 1 Step 2 Step 3 First open lid and turn gas tank on slowly. Turn only one knob on at a time when lighting up the grill. This appliance will be hot during and after use.
PAGE 3
Table of Contents For Your Safety ............... .........................................................................................4 Illustrated Part List.................................................................................................6 Hardware List..........................................................................................................7 Assembly Instructions.......................................................................................
PAGE 4
Dear Valued Customer, For Your Safety Congratulations on your new barbecue grill purchase! You’ve made the right choice. In this manual, you will find assembly instructions, suggestions for grilling and helpful hints, as well as guidelines for the safe operation, proper care and use of your grill. Our expert staff strives to provide you with an easy-to-assemble product.
PAGE 5
WARNINGS Do not use this appliance under overhead combustible surface or covered area (e.g., awnings, umbrellas, porches or gazeboes). Always confirm that this grill is not positioned under the overhang of a house, a garage 6feet 50 inches or other structure before lighting it. An overhang will serve to deflect flare-ups and radiated heat into the structure itself, which could result in a fire.
PAGE 6
Illustrated Parts List Q P Part Description QTY Part Description QTY Part A Lid handle 1 PC F Heat plate 1 PC B Lid 1 PC G Burner C Upper hinge 2 PCS H Regulator D Lower hinge 2 PCS I E Cooking grid 1 PC J P Grease cup 1 PC Q 80102 Owner’s Manual Description QTY K Left handle 1 PC 1 PC L Right handle 1 PC 1 PC M Body assembly 1 PC 1 PC N Left leg 1 PC Heat plate support 2 PC O Right leg 1 PC Lighting rod 1 PC Heat shield 6
PAGE 7
Hardware List AA: 1 PC BB: 15 PCS Wrench M5 × 10 Bolt DD: 15PCS EE: 15 PCS Flat Washer M5 Nut CC: 15 PCS M5 Spring washer FF: 1 PCS M6X7Bolt GG: 7 PCS HH: 7 PCS II: 6 PCS M6 Spring washer Flat washer M6 Nut KK: 2 PCS LL: 2 PCS JJ: 1 PC Screw driver R pin Lid pin Hardware listed above is not scaled to exact size. (A screwdriver is required on assembly and is included for your convenience).
PAGE 8
Assembly Instructions Remove all contents from the carton packaging. Make sure all parts are present before attempting assembly. Once the grill is fully assembled, go back and check to make certain all the bolts are secure. Tighten again using the screwdriver provided if necessary. Estimated Assembly Time: 20 minutes. Step 1 a) Align the holes on the right back side of body assembly M with the holes on the lower hinge b) .
PAGE 9
Step 3 a) Align the holes on the right side of the body assembly with the holes on the heat plate support b) J. Insert the pre-installed bolts on the right handle L into the holes and seal them with one flat washer（HH）, one spring L washer (GG),and one nut(II). c) Repeat the procedure for the left handle K . d) Align the hole on the ignition cable with the hole on the bottom of the body assembly.
PAGE 10
Step 5 a) Place the heat plate b) Place the cooking grid on the heat plate support. upon the heat plate and make certain the cooking grid is clipped by the fastener. Step 6 a) Insert the grease cup P into the two guides underneath the grill and push forward until it is in place. Step 7 a) Insert the pre-attached bolts on the lid handle into the holes on the front of the lid and seal with one flat washer (HH), one spring washer (GG),and one nut (II).
PAGE 11
Step 8 a) Align the holes of the upper hinges on the back of the lid with the holes of the lower hinges on the back of the body. b) Insert one lid pin (LL) into each hole. c) Insert one R pin (KK) into the hole on the front of the lid pin. LL Lid pin 2 PCS KK R pin 2 PCS Step 9 a) Screw the gas cylinder counterclockwise into the thread underneath the regulator valve until it is in place. b) Make certain the connection is secure and conduct the leak test on page 12.
PAGE 12
Operating the Grill CAUTION: Use only the regulator provided. If a replacement is necessary, call our customer service center. The use of unauthorized parts can create an unsafe condition and environment. Connect gas cylinder The propane gas supply cylinder to be used must be constructed and marked in accordance with the Specifications for LP-gas Cylinders of the U.S. Department of Transportation (DOT). Only cylinders marked ‘’propane’’ must be used. Use only 1-pound (16.
PAGE 13
Main Burner 1. Open lid while lighting burners. 2. 3. 4. 5. WARNING: Attempting to light the burner with the lid closed may cause an explosion. Make sure there are no obstructions of airflow to the gas unit. Spiders and insects can nest and clog the burner/ venturi tube at the orifice. A clogged burner tube can lead to a fire beneath the appliance. 1) Push down 2) Turn counterclockwise to “on” All valves must be in the “OFF” position.
PAGE 14
WARNING: Always monitor the grill closely when cooking and turn the flame level down (LOW) or OFF if flareups intensify. Shutting off the burner: Always turn the valve knob clockwise all the way to the “LOCK OFF’’ position. Promptly disconnect the propane cylinder. Excess flow safety valve reset procedure A sudden shut off of the gas flow typically occurs if you open the LP tank valve rapidly. This procedure is effective with all LP tank sizes.
PAGE 15
Troubleshooting Problem Possible Cause Prevention/Cure Burner will not light using a match. No gas flow. Check if propane tank is empty. If empty, replace. If propane tank is not empty, refer to “Excess flow safety valve reset procedure”. . Obstruction of gas flow. Clear burner tube. Disengagement of burner to valve. Reengage burner and valve. Spider webs or insect nest in venturi. Clean venturi. Burner ports clogged or blocked. Clean burner ports. Burner ports are clogged or blocked.
PAGE 16
Warranty Program Proof of purchase is required to access this warranty program, which is in effect from the date of purchase. If unable to provide proof of purchase or after the warranty has expired, customers will be subject to parts, shipping and handling fees. Full 30-Day Warranty Any missing parts can be replaced at no charge within 30 days from the date of purchase with a valid proof of purchase. Limited Warranty 1-Year Limited Warranty on stainless steel tube burners.