Technical data

Reaching the third level “Please charge battery”, indicates that about
40% of battery charge is still available. At stage four of the battery
status, “Charge battery urgently”, recording is not allowed anymore to
protect the messages already recorded. Playback is still possible and
the recorded messages are safeguarded. Four very brief, low pitched
warning beeps sound after each played back message, to alert the
user to recharge the battery. If stage four of the battery status is
reached during a recording, the device will automatically terminate the
recording and will announce the battery status. The performed
recording is saved correctly up to the point at which the battery status
beeps were heard. If you need information on how to recharge
Milestone 312 go to “Battery charging” in this manual.
The built-in rechargeable high capacity battery allows approximately
12 hours of use with one full charge when recording through the
internal microphone and playback over the headphones. Actual power
use varies with the exact use of the device.
3.1.6.2. Local Settings
Local Settings is a menu stream where you can make settings and use additional functions
according to the currently selected device. Let us say you are in the device Audio and go
to the Menu. Now you can select, for example, the reading speed of text files in Local
Settings. In the device Books in turn, other settings are possible.
Choose a sub point by pressing down (”Mode”). You can press down until you reach the
last point. To go up again press “Rec”. If you have reached a sub point where you would
like to settle, press “Right arrow” or “Left arrow” to receive different setting options. The
last position is saved automatically. Direct functions (without selection) you have to confirm
with “Play”. To leave the Menu just press “Selector”.
3.1.6.3. Basic Settings
Basic Settings does not have influence on one device only. Here you can make general
settings independent of the currently active device. An example is setting the clock.
Choose a sub point by pressing down (”Mode”). You can press down until you reach the
last point. To go up again press “Rec”. If you have reached a sub point you would like to
settle, press “Right arrow” or “Left arrow” to receive different setting options. To leave the
Menu just press “Selector”.
Attention: Further settings via computer can be done in a special file on Milestone‘s
internal memory. More about this topic you find under “Customize via CONFIG
MILESTONE.TXT” in this manual.
!
11/40