Technical data

5.2. Radio
5.2.1. General information
The device “Radio” contains a fully functional FM radio in stereo. You have the possibility
to change between pre-selected channels and even to record the radio signal.
5.2.2. Use Radio
Press the “Selector” button on the front end until you hear the announcement “Radio”. Now
you are in the correct device.
Attention: If you have pushed “Selector” on M312 and it does not react, it might have been
in sleep mode. In this case just push the “Play” button and it will react. If you still have no
reaction, please check that the keyboard is not locked, volume is on and the battery has
power. If Milestone 312 is working and you do not find the device Radio, be aware that this
is a software extra that is not in the basic version of M312.
If Milestone is in the Radio device and can not find a radio station, check to see that the
earphones are plugged in.
First you have to plug in earphones (not included in delivery). The cable of the earphone
works as the antenna and consequently is important for the reception. Without earphones
connected you will have difficulty to find a radio signal.
Press “Play” and you can listen to the current adjusted frequency. If you press “Play” again
the playback stops and the device returns to a mute state. If the adjusted frequency only
generates a hissing, push and hold for one second an arrow button to switch to the next
radio channel. With the “Right arrow” button you jump to the next higher frequency, which
is taken by a radio channel. With the “Left arrow” button you reach the next lowest radio
channel. To fine tune you quickly push on one of the arrow buttons and you jump in the
smallest possible frequency unit of 0.1 MHz.
5.2.2.1. Save a radio channel and label it
If you like a radio channel and you want to save it, please hold “Play” for 2 seconds until
you hear a beep tone. The current frequency is now saved. In total you have twelve
memorized stations to save your favorite frequencies. You can change between
memorized stations via “Rec” or “Mode” in paused mode. With “Rec” you reach the next
higher memorized station and the next lower station you reach with “Mode”. You can also
add a name to each station memorized. With the same combination you voice label a
folder in Audio, you can voice label a memorized station in Radio. Push and hold “Rec”
and then in addition push and hold “Mode”. Keep on holding both buttons. Recording
starts after a safety interval of three seconds and ends when the buttons are released. The
device signals start of recording with the sound sequence “low pitched-high pitched” and
end of recording with the sound sequence “high pitched-low pitched”. The new voice label
is heard the next time this memorized station is selected.
Attention: Please be aware that voice labeling a station is only possible when radio
playback is paused.
!
32/40