Technical data

5.2.2.2. Direct Frequency Function

Instead of jumping from one radio channel to the next via arrow buttons, you can also jump

directly on a speciﬁc frequency with the Direct Frequency Function. To use this function

you have to push and hold “Selector” and then in addition enter the frequency with the

“Left arrow”, “Play” and “Right Arrow”. With each push on “Left arrow” you jump between

80, 90, 100 MHz, with “Play” you reach the single-digit ﬁgures 1 to 9 MHz and with “Right

arrow” you select between 0.1 to 0.9 MHz

Let us make an example to demonstrate this with the radio frequency 104.2 MHz. Push

“Selector” and hold it until you have entered the whole frequency. Start now and push “Left

arrow” until you reach 100MHz and then push “Play” 4 times to reach 4 MHz. You have

now entered 104 MHz and would jump to this frequency by releasing “Selector”. But to

ﬁnish the input we ﬁrst have to enter 0.2 MHz. Now press “Right arrow” 2 times. Now the

frequency is complete and you can release “Selector” to jump to the adjusted frequency.

5.2.2.3. Record Radio

If an interesting interview or a great song is played on the radio you have also the

opportunity to record it. Therefore press “Rec” and “Play”, as you would do it in the Audio

device for a longtime recording. To stop the recording press “Rec” once more. To listen to

the recording please change into the Audio device and open the folder “Radio” in the

internal memory. There you will ﬁnd the created ﬁle and can listen to it.

Hint: You can also listen to the radio over the integrated speaker. Therefore push and hold

“Selector” and in addition press “Mode”. In this mode no settings can be done. To go back

to normal use just press “Play”.

33/40