User manual

Page 27
Does the device have adequate power supply? Connect your voice recorder to a power
outlet and ensure that the charger is powered. Recharge the built-in battery for at least half
an hour.
Step 2:
Is the device turned on? Press any button for at least half a second.
Step 3:
Is the keyboard locked? While keeping the “Mode” button (bottom button with an
embossed cross pattern) pressed, press the “Rec” button (top button with round indent the
size of a pinhead) briefly and listen for the response of the device:
You hear the message “Keyboard active”: Keyboard was locked and is now unlocked. Go
directly to step 5.
You hear the message “Keyboard locked”: Keyboard has now just been locked. Press the
same combination of buttons once more to unlock the keyboard. The device will play the
message “Keyboard active”. Go directly to step 5.
You hear no message: The volume of the device is possibly turned down. Keep the “Mode”
button (bottom button with an embossed cross pattern) pressed while simultaneously
pressing down the right arrow button for approximately five seconds. Go to step 4.
Step 4:
Has the locking of the keyboard been activated at low volume? Press the “Play” button
(middle button which contains no symbol) to playback a message.
You hear one beep or a recorded message: The keyboard was not locked. Go directly to
step 5.
You hear no beep and no recorded message: Locking of the keyboard was possibly
activated at low volume. Please repeat the test once from step 3.
If you hear one beep or a recorded message, go directly to step 5.
If you do not hear any beeps or a recorded message, the device is not functioning properly.
Please contact your sales representative.
Step 5:
Is the memory of your device full? Perform a test recording by pressing down on the “Rec”
button (top button with round indent the size of a pinhead), speaking a message and
releasing the “Rec” button.
Press the “Play” button (middle button which contains no symbol) to hear the test recording.
If you hear the test recording, the device is fine and may be used without further
complications. If you do not hear the test recording, the device is not functioning properly.
Please contact your sales representative.
At the beginning of the recording, you hear the message “Memory full”: The memory of your
voice recorder is full or almost full. Delete a message by replaying it and, at the same time,
keeping the “Mode” button (bottom button with an embossed cross pattern) pressed while
pressing the “Play” button (middle button which contains no symbol). Try again to perform a