Operating instructions

102 Application manual Positioning 04/08
4.8.6 Warning mask Application
The logic signals of monitoring and control functions can be selected via parameter
Create Warning Mask 536. For the available options, refer to the operating instruc-
tions. The logic signals of different positioning monitoring functions can be selected
via parameter
Create Appl. Warning Mask 626. As soon as limit switches are
reached or contouring error thresholds are exceeded, a warning can be issued. The
warnings refer to the parameter values set in error/warning behavior in configura-
tions x40. Depending on the application, any number of warnings can be configured.
The warnings are selected via parameter
Create Appl. Warning Mask 626:
Create warning mask application 626
Function
0 - No change
The configured warning mask is not
changed.
2 - Activate all Warnings
The warnings reports stated are linked in
the warning mask.
10 - Warning V-Belt
Warning message of V-belt monitoring
according to
Operation Mode 581.
11 - Warning pos. SW limit switch
Warning message indicating that the posi-
tive SW limit switch has been reached.
12 - Warning neg. SW limit switch
Warning message indicating that the nega-
tive SW limit switch has been reached.
13 - Warning pos. HW limit switch
Warning message indicating that the posi-
tive HW limit switch has been reached.
14 - Warning neg. HW limit switch
Warning message indicating that the nega-
tive HW limit switch has been reached.
15 - Warning position controller
Warning message, indicating that the con-
touring error monitoring range adjusted
with parameter
Warning Threshold 1105
has been left.
102 -
Deactivate All
Warnings
All warnings are deactivated.
110 - Deactivate Warning V-Belt No warning message of V-belt monitoring.
111 -
Deactivate warning pos. SW
limit switch
No warning when positive
SW limit switch is reached.
112 -
Deactivate warning neg. SW
limit switch
No warning when negative
SW limit switch is reached.
113 -
Deactivate warning pos. HW
limit switch
No warning when positive
HW limit switch is reached.
114 -
Deactivate warning neg. HW
limit switch
No warning when negative
HW limit switch is reached.
115 -
Deactivate warning position
controller
No warning message when contouring
error monitoring range adjusted with pa-
rameter
Warning Threshold 1105 has
been left.
Warning messages affecting the positioning functions can be displayed via parame-
ter
Application Warnings 273 as actual values.
In the error environment,
Application Warning Status 367 indicates the current
warnings of the positioning functions.
Application manual Positioning 04/08102