Operating instructions

04/08 Application manual Positioning 169
Chapter No. Name of parameter
Master Settings (el. gear)
4.7.1 1122 Master Position Source
4.7.2 1123 Gear Factor Numerator
4.7.2 1124 Gear Factor Denominator
4.7.3
1142
Resy
nc. on Change of Gear-
Factor
4.7.4 1125 Phasing: Offset
4.7.4 1126 Phasing: Speed
4.7.4 1127 Phasing: Acceleration
4.7.4 1128 Start Phasing
4.4.1.5 1168 ”In-Gear”-Threshold
4.4.1.5 1169 “In-Gear“-Time
Actual
value:
6.1;
4.4.1.5
1129 Act. Master Speed
Monitoring functions:
Hardware Limit Switch
4.8.2.2 1143 Fault Reaction
4.8.2 1137 Neg. HW Limit Switch
4.8.2 1138 Pos. HW Limit Switch
4.8.2.1 1149 Hysteresis
Software limit switches
4.8.3 1144 Fault Reaction
4.8.3 1145 Pos. SW Limit Switch
4.8.3 1146 Neg. SW Limit Switch
Contouring error monitoring
4.8.5 1105 Warning Threshold
4.8.5 1106 Error Threshold
4.8.5 1119 Contouring Error Time
4.8.5 1120 Fault Reaction
Actual
values:
6.1;
4.8.5
1109 Act. Contouring Error
6.1;
4.8.5
1121
Peak Value Contouring Error
Target Window
4.8.4 1165 Target Window
4.8.4 1166 Target Window Time
Warning application
4.8.6 626 Create Appl. Warning Mask
Actual values:
6.1;
4.8.6
273 Application Warnings
6.7;
4.8.6
367 Application
Warning Status
6.1;
4.8.6
627
Actual Appl. Warning Mask
Chapter No. Name of parameter
Speed Override
4.9 1236 Speed Override
Rotary table
4.11 1240 Operation Mode
4.11 1241 Units Per Revolution
Position controller
4.12 1104 Time Constant
4.12 1118 Limitation
Position encoder
3.5.1 1141 Actual Position Source
Act. values
6.1 1107 Act. Speed
6.1 1108 Act. Position
Latching function
4.13 1280 Operation Mode
Actual value:
4.13 1281 Latched Position
Application manual Positioning 16904/08