Operating instructions

04/08 Application manual Positioning 43
Motion Mode 1208
Function
23 -
Gearing, direct sync.,
Touch-Probe: Falling
Edge
Operation mode 3 is combined with the electronic
gearing function. The drive is accelerated to the
master speed. At the start of a motion block the
drive is sychronised with the master drive directly.
24 -
Gearing, direct syn-
chronisation
Like operation mode 4, but the drive moves at the
speed profile defined by the electronic gear. The
target position is not relevant and is not evaluated.
The drive is accelerated to the master speed. At the
start of a motion block the drive is sychronised with
the master drive directly.
Note: If both a motor and a position encoder (two different encoders) are
used, the function "Electronic Gear" cannot be used. Also refer to sec-
tion "
Two different encoders for motor and positioning", chapter
3.5.1.2.
The motion mode of the actual motion block can be displayed via parameter Actual
Motion Mode
1255.
Application manual Positioning 4304/08