Operating instructions

08/06 23
5 Parameter list
T
he parameter list is structured accordin
g
to the menu branches of the control unit.
For better clarity, the parameters are marked with pictograms:
The parameter is available in the four data sets
The parameter value is adjusted by the SETUP routine if a control method for a
synchronous machine is selected for parameter C
onfiguration 30.
This parameter cannot be written in the operation of the frequency inverter
5.1 Actual value menu (VAL)
Actual values of the machine
No. Description Unit Display range Chapter
219 Frequency speed sensor 2 Hz 0.0 ... 999.99 4.4
220 Speed, speed sensor 2 rpm 0 ... 60000 4.4
Actual values of the frequency inverter
253 Analog input EM-S1INA % -100 ... +100 4.4
5.2 Parameter menu (PARA)
Resolver
No. Description Unit Setting range Chapter
380 Operation mode - Selection 4.2
381 No. of pole pairs - 1 ... 24
4.2
382 Offset ° -360.0 ... 360.0
4.2.1
Analog input
560 Tolerance band % 0.00 ... 25.00 4.1.6
561 Filter time constant - Selection 4.1.9
562 Operation mode - Selection 4.1.4
563 Error/warning behavior - Selection 4.1.7
564 Characteristic point X1 % -100.00 ... 100.00 4.1.3
565 Characteristic point Y1 % -100.00 ... 100.00 4.1.3
566 Characteristic point X2 % -100.00 ... 100.00 4.1.3
567 Characteristic point Y2 % -100.00 ... 100.00 4.1.3
568 Adjustment - Selection 4.1.8
Speed controller
766 Actual speed source - Selection 4.2.2