USER MANUAL
WARNING To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. To reduce the risk of electrical shock, do not open the electric compartment. Refer servicing to qualified personnel only. To reduce the risk of fire, do not cover the ventilation of the apparatus with newspapers, tablecloths, curtains etc. Do not place lighted candles or other incendiary devices on the apparatus.
__!! WARNING : IMPORTANT !!__ Read the entire “Wing and Foam Fitting” section before first use. Follow the instructions carefully. Improper fit may result in permanent hearing damage. If using the headset daily, it is highly recommended that you change your Foam Ear Tips at least once a week to ensure maximum hearing protection. __!! WARNING : IMPORTANT !!__ Table of Contents 1.
2. IMPORTANT SAFETY INFORMATION 6 2.1 Warnings 6 2.2 Special Conditions for Intrinsically Safe Use 6 3. PACKAGE CONTENTS 7 4. DEVICE DESCRIPTION 8 5. ATTACHMENT OF REPLACEABLE PARTS 9 5.1 Attaching Ear Wings 9 5.2 Attaching Foam Ear Tips 9 5.3 Replacing Wind Screens 9 6. WING AND FOAM FITTING 11 6.1 Troubleshooting Fit 12 7. BASIC FUNCTIONS 12 7.1 Powering On 12 7.2 Powering Off 12 7.3 Adjusting the Listening Audio Volume 13 7.4 Muting and Unmuting the Listening Audio 13 7.
9.3.2.1 Answering and Rejecting Phone Calls 17 9.3.2.2 Hanging up a Phone Call 17 9.3.2.3 Transferring a call to the Phone 17 9.3.2.4 Muting and Unmuting the microphone 17 9.3.3 Media Streaming button functions 17 9.3.3.1 Playing and Pausing media 17 9.3.3.2 Skipping Tracks 17 10. FUNCTION INDICATOR LED 17 11. BUTTON FUNCTIONS QUICK REFERENCE 19 12. ADDITIONAL INFORMATION 20 12.1 Warranty 20 12.2 Limitation of Liability 20 12.3 Maintenance 20 12.4 Important Notice 21 12.
1. INTRODUCTION Thank you for purchasing the CLEAR 360 PRO Hearing Protection System. The CLEAR 360 PRO system provides hearing protection in loud noise environments. It will prevent dangerous sound pressure levels from entering your ears while maintaining full awareness of your surroundings. The system uses patented Bongiovi Acoustic Labs V3D™ technology to provide a natural 360° sound field for maximum safety and comfort.
● ● ● ● Only use the approved CLEAR 360 PRO (or compatible) Charger and Charging Cable to charge the battery. Only charge the battery in a non-hazardous location. Do not use this device if there is a risk that the connecting wires could be caught up during use. The CLEAR 360 PRO uses level-dependent attenuation. Therefore the user should always check operation before use. If distortion or failure is detected, the user should refer to the manufacturer’s advice for maintenance or replacement.
4.
5. ATTACHMENT OF REPLACEABLE PARTS 5.1 Attaching Ear Wings IMPORTANT: Attach the Medium size Ear Wings before first use. Only try a different size if there is a problem with the fit. (See “6. Wing and Foam Fitting”) 1. 2. Orient the Ear Wing so that the rounded portion is facing towards the top and rear of the Ear Piece. a. The opening should be facing towards the front of the Ear Piece. Press the Ear Wing firmly onto the base of the post on the Ear Piece. a.
2. 3. Lift up on the back of the Wind Screen to release the rear clip and rock the Wind Screen forward. Lift the Wind Screen off of the Ear Piece. ____________________________________________ To replace the Wind Screen: 1. 2. Insert the forward tab on the Wind Screen into the front socket on the face of the Ear Piece. Rock the Wind Screen towards the rear of the Ear Piece and press to lock the rear clip on the Wind Screen into the rear socket on the Ear Piece.
6. WING AND FOAM FITTING 1. Attach the Medium size Ear Wings to the Ear Piece by pressing it onto the base of the post. When installed correctly, the wing will lock onto the tabs on the Ear Piece and will not be able to rotate. (See “5.1 Attaching Ear Wings”) 2. Attach the Large size Foam Ear Tips to the Ear Piece by inserting the post on the Ear Piece into the center of the Foam Ear Tip. Press firmly until the post is fully inserted into the middle of the Foam Ear Tip as deep as possible. (See “5.
6.1 Troubleshooting Fit 1. 2. 3. If the Ear Wing does not fully seat into the fold of the ear, the Ear Wing may be too large. Repeat “WING AND FOAM FITTING” steps 1-7 using the Small size Ear Wing. If the Ear Wing still does not fully seat into the fold of the ear, the Foam Ear Tip may be too large. Repeat “WING AND FOAM FITTING” steps 2-7 using the Medium size Foam Ear Tips. If the Ear Wing still does not fully seat, repeat “WING AND FOAM FITTING” steps 2-7 using the Small size Foam Ear Tips.
7.3 Adjusting the Listening Audio Volume ● ● The loudness of listening (environmental) audio can be decreased by pressing the Volume DOWN button. o A single short press of the Volume DOWN button will decrease the level by small steps. o Long pressing and holding the Volume DOWN button will continually decrease the level until the button is released. o A beep will play when the device is set to its minimum volume level. The loudness of listening audio can be increased by pressing the Volume UP button.
▪ o o “More than 8 hours remaining” will play if you have at least 8 hours of remaining battery life with normal use. ● The Function Indicator LED will flash red four times. ▪ “Less than 8 hours remaining” will play if you have less than 8 hours of remaining battery life. ● The Function Indicator LED will flash red three times. ▪ “Battery charge low” will play once the battery level drops below 30%. ● The Function Indicator LED will flash red two times.
9. BLUETOOTH™ INFORMATION AND FUNCTIONS If Bluetooth™ is installed on your CLEAR 360 PRO unit, your headset will be able to wirelessly connect to most models of 2-way radios, mobile phones, and many other devices that support the Bluetooth™ specifications. If you do not have Bluetooth™ installed, you may skip this section. 9.1 Bluetooth™ Information 9.1.
● ● ● Connection with all Bluetooth™ devices cannot be guaranteed: o A device featuring Bluetooth™ function is required to conform to the Bluetooth™ standard specified by the Bluetooth™ SIG and must be authenticated. o Even if the device conforms to the above mentioned Bluetooth™ standard, some devices may not be connected or work correctly, depending on the features or specifications of the device.
o o This will clear all paired devices from your CLEAR 360 PROs memory. All devices will need to be paired again in order to use Bluetooth™ 9.3.1.2 Using voice assistants ● Your CLEAR 360 PRO is capable of activating the voice assistant (IE: Siri, Google Assistant, etc.) on your paired device if it has one. ● To activate your voice assistant, press and hold the Multi-Function Button (MFB) for 1 second until you hear a beep. ____________________________________________ 9.3.2 Phone Call button functions 9.
● ● ● ● On without Bluetooth™ Connection: While the device is powered on and no device is connected via Bluetooth™, the LED will flash BLUE once every two seconds. On with Bluetooth™ Connection: While the device is powered on and actively connected via Bluetooth™, the LED will flash BLUE once every five seconds. Low Battery: If the device is powered on and the battery life is low, the LED will flash RED once every three seconds.
11.
12. ADDITIONAL INFORMATION 12.1 Warranty There is a two year guarantee against defects in materials and workmanship.
● The CLEAR 360 PRO should be stored at room temperature - between 59° F (15° C) and 77° F (25° C). If you are storing for longer periods of time (greater than 1 month) discharge the unit for at least 2 hours before storing for maximum battery life. ____________________________________________ 12.
13. CERTIFICATIONS AND SAFETY APPROVALS 13.1 Certificate of Compliance–Restriction of the use of Hazardous Substances (RoHs) We certify that all of our products (exceptions - see list below) are compliant with the European Union Directive 2002/95/EC for the Restriction of the use of certain Hazardous Substances in Electrical and Electronic Equipment (RoHs). No Lead (Pb), Cadmium (Cd), Mercury (Hg), Hexavalent Chromium (Cr+6), PBB or PBDE is intentionally added to these devices.
_____________________________________________________________________________ 23
Patents and design registration are pending internationally. © 2020 Bongiovi Acoustic Labs © 2020 Bongiovi DPS are registered trademarks of Bongiovi Acoustics, LLC. The Bluetooth™ word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. All other trademarks included herein are the property of their respective owners. (Design and specifications subject to change without notice). Made in China Responsible Party CLEAR 360 VENTURES BONGIOVI ACOUSTIC LABS 649 SW Whitmore Drive Port St.