User's Manual

3. Camera Placement ( on the wall )
Note: If the drywall anchor cannot
be screwed into the wall easily,
you may hit a stud in this
case. No drywall
anchor is required
for this hole.
Use the screwdriver to make two
horizontal holes in the drywall.
The distance between the two
holes is equal to the distance
between the two holes in the
wall mount shim.
Put the baby unit (camera) into the wall mount. Rotate the baby unit (camera) clockwise
about 90 degrees until it clicks.
Note: As the reference picture shows
below, place the baby unit in
the center of the wall mount.
Push two drywall anchors into
the hole and screw them in until
they are flush with the wall.
Position the wall mount over the anchor
hole. Screw the screw into the hole, then
secure the wall mount until it's tight.
Note: Do not overtighten the
wall mount.
EN
1204
Step 1.
Step 4. Step 5.
Step 2. Step 3.