Bicycle SEATPOST OWNER'S MANUAL 243705

ManualsBrandsBontrager ManualsBicycle Accessories243705

BONTRAGER SEATPOST OWNER'S MANUAL

Part Number 243705

Figure 1- Bontrager seatpost

Table of contents

Read this manual before you ride

...............................................................

Inspect your seatpost regularly

...............................................................

.....

Installation instructions

...............................................................

.................

Bontrager warranty

...............................................................

........................

Summary of content (4 pages)

PAGE 1
Part Number 243705 BONTRAGER SEATPOST OWNER'S MANUAL Figure 1- Bontrager seatpost Table of contents Read this manual before you ride .................................................................2 Inspect your seatpost regularly ....................................................................2 Installation instructions................................................................................3 Bontrager warranty..................................................................................
PAGE 2
READ THIS MANUAL BEFORE YOU RIDE Please read this instruction manual thoroughly before using your new seatpost; it contains important safety and maintenance information. If you do not understand the information in this manual, or you have a question about your seatpost that this manual does not cover, consult your Bontrager dealer. If you have a question or problem that your Bontrager dealer can’t handle, contact us at: Bontrager Components (800) 369-8735 Attn: Customer Service http://www.bontrager.
PAGE 3
Installation instructions Generally, it is easier to remove the saddle with the seatpost held firmly in the bike frame. However, the old seatpost may be corroded slightly, making removal or the seatpost difficult without the seat attached for leverage and grip. These instructions explain how to remove a seatpost that may be slightly corroded. To remove an old seatpost 1. 2. 3. 4. Loosen the seatpost binder bolt. Twist the saddle to loosen and partially remove the seatpost from the frame.
PAGE 4
To adjust the saddle tilt 1. Loosen the saddle clamp bolt several turns. 2. While tilting the saddle, apply pressure to the top of the saddle directly above the saddle clamp. Pressure on the saddle helps release the compression wedges. 3. Tilt the saddle to the desired angle. 4. Follow the Inspection procedures to re-tighten the saddle clamp bolt. This line must be hidden inside the bike frame To adjust the saddle height Figure 5- Minimum insertion mark on seatpost 1.