boost TM 1/10 Electric buggy ECX3000 | ECX3000AU | ECX3100 | ECX3100AU Instruction Manual Bedienungsanleitung Manuel d’utilisation MANUALE Congratulations on your purchase of the Electrix RCTM BoostTM Buggy. This 1/10-scale model introduces you to the sport of RC driving. Herzlichen Glückwunsch zum Kauf des Electrix RCTM CircuitTM Stadium Truck. Dieses 1/10 Scale Model öffnet Ihnen die Welt des RC Car Sports. Nous vous félicitons pour l’achat du Electrix RCTM CircuitTM Stadium Truck.
EN NOTICE All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, Inc. For up-to-date product literature, visit www.horizonhobby.com and click on the support tab for this product.
EN Specifications Transmitter Frequency Modulation Battery Current Consumption Size Weight 27MHz Pulse Proportional Modulation (PPM) AA x 8 200mAh 17 x 23.5 x 7.5mm 382 g Servo Power Supply Output Torque Operating Speed Size 4.8V~6V (shared with receiver) 41.66 oz (3 kg-cm) 0.23sec/60 degrees of travel 40.5 x 20 x 36.
EN Installing Transmitter Batteries 1. Slide panel open on bottom of transmitter. 2. Obey battery plus (+) and minus (-) diagram in transmitter to install 8 AA batteries. 3. Slide panel closed on transmitter. CAUTION: ALWAYS use fully charged batteries in the transmitter. Low battery power can result in loss of control of the RC vehicle. NEVER install damaged batteries, batteries of mixed types or batteries of different ages in the transmitter. Remove exhausted batteries.
EN Installing Vehicle Battery 1. 2. 3. 4. 5. Turn the thumb nuts to remove the battery strap. Install the battery. Install the battery strap. Turn the thumb nuts to secure the battery strap. Connect the battery. OperatioN Operating Precautions and Guidelines • ALWAYS turn on your transmitter before you turn on the receiver in the car. Always turn off the receiver before turning your transmitter off. • ALWAYS operate vehicle in a wide open area.
EN Transmitter Controls AM 27MHz Transmitter Crystal Reverse Switch Antenna Pull antenna out to its full length (ECX1067 Antenna Only) Part # ECX1081 ECX1082 ECX1083 ECX1084 ECX1085 ECX1086 Description Crystal Set 1 26.995 Crystal Set 2 27.045 Crystal Set 3 27.095 Crystal Set 4 27.145 Crystal Set 5 27.195 Crystal Set 6 27.255 AM Transmitter Crystal (Tx) Allows you to change the direction of steering (ST. REV) and throttle (TH. REV) controls.
EN Getting Started 1. Fully extend Antenna and Power on Transmitter. 2. Connect battery to Electronic Speed Control (ESC) and power on the ESC. 3. Do a Test of Transmitter’s control of vehicle with vehicle wheels off ground. 4. Start driving slowly and if the vehicle does not go straight, adjust steering trim dial on Transmitter. Note: Seat motor brushes by driving smoothly on a flat surface during use of the first battery charge. When you are Finished 1. Power off Electronic Speed Control (ESC).
EN Setting the gear mesh Precautions Gear mesh has already been set at the factory, and setting it is only necessary when changing motors or gears. • Never touch moving parts. • Never disassemble while batteries installed. • Always let parts cool before touching. Note: You must remove the vehicle’s gear cover (A) to do this adjustment. Proper gear mesh (how gear teeth meet) is important to the performance of the vehicle.
EN Maintenance Rear Shock Rear shock Shock Cleaning • Oil-filled shocks will require regular maintenance due to the oil breaking down or getting dirty. This maintenance should be performed after about every 3 to 5 hours of use depending on conditions that the vehicle is used in. • Remove the shock from the vehicle. • Remove the cap from the shock body and dispose of fluid. • Disassemble the shock. Clean thoroughly with DYN5505. Dry parts before assembly.
EN Warranty and repair policy Warranty Period WARRANTY SERVICES Exclusive Warranty- Horizon Hobby, Inc., (Horizon) warranties that the Products purchased (the “Product”) will be free from defects in materials and workmanship at the date of purchase by the Purchaser. Questions, Assistance, and Repairs Limited Warranty Horizon reserves the right to change or modify this warranty without notice and disclaims all other warranties, express or implied.
EN Contact information Country of Purchase Horizon Hobby United States of America Horizon Service Center (Electronics and engines) Horizon Product Support Address Phone Number / Email Address 4105 Fieldstone Rd Champaign, Illinois 61822 USA 877-504-0233 Online Repair Request visit: www.horizonhobby.com/repairs +44 (0) 1279 641 097 sales@horizonhobby.co.
Fasteners | Befestigungen | piéces servant à la fixation | viteria Description | Beschreibung Description | Descrizione M3x10mm TAPPING BINDER HEAD Linsenkopfschraube Vis auto-taraudeuse tête Vite autofilettante testa tonda M3x12mm TAPPING BINDER HEAD Linsenkopfschraube Vis auto-taraudeuse tête Vite autofilettante testa tonda M3x16mm TAPPING BINDER HEAD Linsenkopfschraube Vis auto-taraudeuse tête Vite autofilettante testa tonda Description | Beschreibung Description | Beschreibung Description | Descrizione
Parts Diagram | explosionszeichnung | vue éclatée des Piéces | esploso del modello con referenza pezzi M3X25 Recommended Items Empfohlene Werkzeuge Outils Recommandés Attrezzi raccomandati M3X10 8 M3X10 10 47 3 M4.3X13 10 6 2 10 M3X12 7 4 20 47 6 M3X12 13 M4.3X13 14 M4.3X13 6 2 1 17 M3X18 M3X12 M3X8 M3X12 M2X8 M3X12 M3X18 2 20 11 32 M3X12 M3X16 31 M3X18 M4.3X13 7 M3X25 6 21 19 23 16 31 M2.
Parts Diagram | explosionszeichnung | vue éclatée des Piéces | esploso del modello con referenza pezzi Note: The slipper clutch can be adjusted using this locknut (ECX1060). Fully tighten the locknut. Then loosen the nut two full turns. Die Rutschkupplung kann durch diese Stopmutter eingestellt werden (ECX1060). Ziehen Sie die Mutter an und drehen Sie dann volle zwei Umdrehungen zurück. A noter: Il est possible d’ajuster l’embrayage “patinant” par action sur cet écrou de blocage (ECX1060).
Part # | Nummer Numéro | Codice Description Beschreibung Description Descrizione Telaio principale 1 ECX3007 Main Chassis Chassis Châssis principal 2 ECX1028 Servo Saver Set Servo Saver Set Jeu de sauvegarde de servo Set salvaservo 3 ECX1092 Rear Suspension Mount Set Querlenkerhalter hinten Jeu de renfort de suspension arriére Supporti braccetti sosp.
Part # | Nummer Numéro | Codice Description Beschreibung Description Descrizione 46 ECX1033 Setscrew M3x10 Sicherungsschrauben (4) Vis (4) Viti (4) 47 ECX1029 Top Plate Chassioberteil Plaque frontale Piastra superiore Country of Purchase Horizon Hobby Address Phone Number / Email Address Sales 4105 Fieldstone Rd Champaign, Illinois 61822 USA (800) 338-4639 sales@horizonhobby.
NOTES | HINWEIS | A NOTER | Nota boost TM 47
Created 1/11 28957 © 2011 Horizon Hobby, Inc.