Use and Care Manual

Operation
To reduce the risk of injury, wear safety goggles or
glasses with side shields. Always wait for the bit to
stop completely and unplug the tool before changing
accessories or making adjustments. Never make
adjustments while the router is running. Do not modify
or remove the guards.
Do not use this router unless it is securely installed into
a recommended router lift and table.
Contents
Check the contents of the box carefully before using the tool.
(1) Router motor (1) ¼” collet (2) Spare motor brushes
(2) Offset wrenches (1) ½” collet
Variable Speed Dial
The variable speed dial allows you to adjust the rotating speed (RPM) of the tool.
Use the following chart to determine the best speed for the bit diameter.
Speed Setting RPM Max. Bit Diameter
Slow 10,000 3” to 3-½”
Slow 12,000 3” to 3-½”
Medium 14,000 2-¼” to 2-½”
Medium 16,000 2-¼” to 2-½”
Medium 18,000 1-¼” to 2”
Fast 20,000 1”
Fast 22,000 1”
Electronic Overload Protection
Before the motor is overloaded, the electronic overload protection circuit will turn
off the tool.
Soft Start
The Soft-Start feature reduces the amount of torque reaction of the tool. This feature
gradually increases the motor speed up from zero to the speed set by the variable speed dial.
Feedback Control
The electronic speed control system allows the tool to maintain constant speed between
no-load and load conditions.
11