Use and Care Manual

22. Do not force tool. Your tool will perform best at the rate for which it was designed.
Excessive force only causes operator fatigue, increased wear and reduced control.
23. Use the right tool. Do not use a tool or attachment to do a job for which it is not
recommended.
24. Unplug tool when it is not in use before changing accessories or performing
recommended maintenance.
25. Store idle tools. When not in use, store your tool in a dry, secured place. Keep out
of reach of children.
26. Never leave the tool running unattended. Turn power off. Do not leave the tool
until it comes to a complete stop.
27. Check for damaged parts. Inspect guards and other parts before use. Check for
misalignment, binding of moving parts, improper mounting, broken parts and any
other conditions that may affect operation. If abnormal noise or vibration occurs, turn
the tool off immediately and have the problem corrected before further use. Do not
use a damaged tool.
28. Use proper accessories. Consult this manual for recommended accessories. Using
improper accessories may be hazardous. Be sure accessories are properly installed
and maintained. Do not discard a guard or other safety device when installing an
accessory or attachment.
29. Maintain tools carefully. Keep cutting edges sharp and clean. Follow instructions
for lubricating and changing accessories. Periodically inspect tool cords and
extension cords for damage. Have damaged parts repaired or replaced by
PortaMate.
30. Maintain labels & nameplates. These carry important information.
Service
31. Service or maintenance performed by unqualified personnel may result in a risk of
injury.
32. When servicing a tool, use only identical replacement parts. Follow instructions
in the maintenance section of the manual. Use of unauthorized parts or failure to
follow maintenance instructions may create a risk of shock or injury.
33. Note that 2 spare motor brushes are included with your router.
5