Use and Care Manual

7
unexpectedly shift, causing loss of control. Loose rotating components will be violently
thrown. Watch for vibration or wobbling that could indicate an improperly installed bit.
Always keep the power supply cord away from moving parts on the tool.
Never start the tool when the bit is in contact with the material. The bit cutting edge
may grab the material causing loss of control of the workpiece.
Never touch the bit during or immediately after use. After use the bit may be hot
enough to burn bare skin.
To reduce the risk of injury, avoid “climb cutting.” Climb cutting can cause the
workpiece to be thrown violently out of your control. Even small router bits can result in
climb cutting. Always feed the workpiece against the cutter rotation.
Symbology
Specifications
Volts AC Horsepower No Load RPM
120 3.25 hp* 10,000 – 22,000
Double Insulated
Volts Alternating Current
No Load Revolutions per Minute (RPM)
Amperes
Do not expose to rain or use in damp locations