Use and Care Manual

Tool Assembly

To reduce the risk of injury, always unplug tool

before attaching or removing accessories or making

adjustments. Use only specifically recommended

accessories. Others may be hazardous.

Collets

The collet must be attached to the collet nut

before it is put into the collet shaft. Be sure

that the size of the collet matches the size of

the bit shank being used. If the wrong size

bit shank is used, the collet may break. For

attaching or detaching the collet nut to the

collet, follow the illustrated instructions on this

page.

Attaching Collet to Collet Nut:

This product includes a ¼” and ½” collet, as

shown in Fig. 1

To assemble the collet or to replace a broken

part, complete the following steps:

a. Using snap ring pliers – open the snap ring

and remove it.

b. Loosen the collet completely and replace

the broken part.

c. Tighten the collet completely and replace

the snap ring.

Fig. 1