User Manual

1. First, setup your Bora Clamp Edge (note: in a few steps, we

will be suggesting you make a test cut the first time you use

the Jigsaw plate, so you may wish to use the clamp edge on a

piece of scrap first.)

2. Facing the way you will be cutting, slide the tongue of the

Jigsaw plate into the right hand groove of the Clamp Edge –

ensure both front and rear tongue pieces are fully slid into the

clamp edge’s groove.

3. Unscrew the screw handle, and slide the plate holder open (to

the right). Make sure it’s larger than your jigsaw’s plate.

4. Lay your jigsaw in the opening, resting the left side of your

jigsaw’s plate on the “shelf edge” of the opening.

5. Slide the plate holder closed so, ensuring the right hand

shelf is also under your saw’s plate, and the right side is snug

against your saw’s plate. Tighten. Note that your saw and

its plate simply rests on the Bora Jigsaw Plate, and is never

actually attached to it.

6. You can now make a test cut. Slide your jigsaw forward as

shown and make a cut.

7. You can now lift your saw out and put it aside, unscrew the

blade guide, line it up with your cut, and tighten.

8. Place your saw back into the Jigsaw plate (you should be

able to simply place it back in without untightening the screw

handle, although always make sure it’s snug against the sides

of the plate.) You’re ready to work.

Using the Bora Jigsaw Guide

an division of TOOL WORKS

part of the TOOL WORKS group of companies

part of the TOOL WORKS family of companies

proudly distributed in the USA by TOOL WORKS

3-5